CONTROL GP-HYDRAULIC 1V4893 - Caterpillar

Illustration 1 g00516514
Note: During assembly, inspect the following components for any foreign materials: the front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds and any other foreign material. Apply a small amount of 8T-9022 Silicone Gasket in order to fill the space between the following components: the cylinder block, the flywheel housing and the oil pan. After the flywheel housing is installed, cut the gasket even with the pan rail. (1) BoltIn order to tighten the flywheel housing bolts, use the procedure that follows:
In a numerical sequence, tighten flywheel housing bolt 1 through bolt 24.Tighten the bolts to the following torque. ... 40 10 N m (30 7 lb ft)
In a numerical sequence, tighten flywheel housing bolt 1 through bolt 9.Tighten the bolts to the following torque. ... 135 20 N m (100 15 lb ft)
In a numerical sequence, tighten flywheel housing bolt 10 through bolt 24.Tighten the bolts to the following torque. ... 55 10 N m (41 7 lb ft) (2) Seal The wear sleeve should be installed to the following depth from the rear face of the crankshaft. ... 1.5 0.5 mm (0.06 0.02 inch)Note: The seal driver can not contact the seal inside a 177.80 0.25 mm (7.000 0.010 inch) diameter.Note: Refer to Special Instruction, SMHS8508 for the correct procedure on installation of the seal.