CONTROL GP-HANDLE 2068917 - Caterpillar

Install Tooling (B) .
Illustration 9 g00704440
Use Tooling (A) in order to remove retaining ring (11) .
Illustration 10 g00704806
Remove cover (12) .
Illustration 11 g00704817
Remove shaft seal (13) .
Illustration 12 g00843403
Remove O-ring seal (14) .
Illustration 13 g00843399
Remove shims (15) .
Illustration 14 g00704813
Install Tooling (C) .Note: Use shrink wrap or electrical tape in order to protect the shaft.
Illustration 15 g00704450
Remove the rotary group from housing (1) .
Illustration 16 g00848530
Remove Tooling (B). Remove barrel (16) .
Illustration 17 g00720503
Remove spring (17) and shim (18) from barrel (16) .
Illustration 18 g00848531
Remove screws (19) from retainer plate (20) .
Illustration 19 g00704502
Remove pistons (21) from retainer plate (20) .
Illustration 20 g00848532
Break out piston rings (22) from pistons (21) .
Illustration 21 g00704507
Remove shim (23) and center pin (24) .
Illustration 22 g00704510
Use Tooling (D) in order to remove retaining ring (25) .
Illustration 23 g01220816
Use Tooling (E) in order to remove the bearing cup, cone (26), the remaining bearing cup, and cone (27) from shaft (28) .