CONTROL GP-JOYSTICK 2254812 - Caterpillar

Which Generate This Code:The pitch of the blade requires resetting.System Response:The function of "ABA" will not be available.Test Step 1. Resetting Procedure
Press the "ABA" key (7) of the VIDS keypad. This key will arm the "ABA". When the "ABA" key (7) is first pressed, the ABA indicator on the right column will be illuminated and the message center will temporarily show: "ABA CONTROL IS NOW ON". When the "ABA" is first armed, the ECM does not know the position of the tilt cylinders. When the "ABA" is first armed, the process of resetting must occur. The operator is prompted to start the process.Note: Once "ABA" is armed, pressing the mode select switch may cause "ABA" to automatically move the blade. After "ABA" is first armed, the message center will show: "BLD PITCH NOT RESET" "RESET W/MODE SELECT".
Then, the operator presses the mode select switch on the blade control handle. Now, the ECM will automatically retract the tilt cylinders to the full back position. During this time, the message center will show: "RESETTING". The ECM will activate the pitch solenoid and the tilt left solenoid. The solenoids activate for a period of time in order to allow the tilt cylinders to retract fully. When the cylinders are retracted fully, this position is called the zero pitch position.Note: The process of resetting is faster at higher engine speeds.
The ECM will move the pitch of the blade to the load position automatically, after the cylinders are retracted fully. At this time, the message center will show: "REDY TO CARY". The function of "ABA" is now active. The "ABA" must be armed and the "ABA" must be active in order for the function of AUTO pitch to operate. Note: The function of AUTO pitch will not reset properly, if the operator adjusts the pitch of the blade during the process of resetting. The operator must press the mode select switch again in order to restart the process of resetting.Expected Result:The process of resetting was successful.Results:
YES - The process of resetting was successful. Resume normal machine operation.STOP
NO - The process of resetting was NOT successful. Exit this procedure and perform this procedure again.STOP