CONTROL GP-ENGINE ELECTRONIC 2405304 - Caterpillar

TYPE="TABLE" @@@-->
Table 1
Required Tools
Tool Part Number Part Description Qty
A 165-2601 Silicone Sealant 1 Front sealant
Illustration 1 g01254690
Applying sealant
Apply Tooling (A) to the cylinder block and to the timing case.Note: Apply a sealant bead of 3.5 mm (0.1378 inch) that is shown in illustration 1.Rear sealant
Note: Install the rear oil seal before sealant is applied to the bridge.
Illustration 2 g01254887
Applying sealant
ApplyTooling (A) to the bridge. The sealant must not protrude more than 5 mm (0.1969 inch) above the bridge.
Illustration 3 g01255016
Typical example
(1) Tighten the four front bolts in position (X) to the following torque. ... 22 N m (16 lb ft)Tighten the remaining bolts to the following torque. ... 22 N m (16 lb ft) (2) Drain plug Tighten the drain plug for the engine oil pan to the following torque. ... 34 N m (25 lb ft)