CONTROL & MTG GP-JOYSTICK 2414278 - Caterpillar

Illustration 17 g00502264
Remove the bolt (28) and the washer. Remove bolt (29) .
Remove the side panel.
Illustration 18 g00502272
Illustration 19 g00520950
The base of the right side support assembly.
Draw the outline of the support assembly flange (30) on the wall plate assembly (31). This is very critical for the installation procedures in order to place the wall plate assembly in the proper position.Note: Do not loosen or remove the bolts at the base of the support assembly. The support assembly flange establishes the correct position for installing the wall plate assembly, the fuel tank, and the hydraulic tank. If the position of the support assembly flange is changed, proper alignment of the wall plate assembly, the fuel tank, and the hydraulic tank may not be possible.
Remove three bolts and washers (32) and remove two bolts and washers (33) .
Illustration 20 g00502274
Draw the outline of support assembly flange (34) on wall plate assembly (31). This is very critical for the installation procedures in order to place the wall plate assembly in the proper position.Note: Do not loosen or remove the bolts at the base of the support assembly. The support assembly establishes the correct positioning for the installation of the wall plate assembly, the fuel tank, and the hydraulic tank in this procedure. If the position of the support assembly is changed, correct alignment of the wall plate assembly, the fuel tank, and the hydraulic tank may not be possible.
Remove three bolts (35) and washers. Remove two bolts (36) and washers.
Illustration 21 g00502276
Install tooling (A) and apply suitable lifting straps. Remove the wall plate assembly (31). The weight of the wall plate assembly is 29 kg (65 lb).
Illustration 22 g00502279
Remove two bolts (37) and washers. Remove bracket (38). Lay the metal tubes aside so that the tubes do not interfere with the removal procedure.
Illustration 23 g00502282
Disconnect the four hose assemblies (39) .
Illustration 24 g00502368
Loosen hose clamp assembly (40). Disconnect hose (41) .
Illustration 25 g00503246
Loosen two hose clamp assemblies (42). Disconnect hoses (43) .
Illustration 26 g00503250
Remove the bolt (44) and the washer.
Illustration 27 g00503251
Remove the bolt (45) and the washer.
Illustration 28 g00503252
Loosen two nuts (46) and remove the dozer cable.
Remove two bolts (47) and washers.
Illustration 29 g00503969
Apply tooling (A) and suitable lifting straps.
Slowly raise the hydraulic tank until the tank discharge line and hose clamp are visible. The weight of an empty hydraulic tank is 23 kg (50 lb). Loosen the hose clamp and remove the hose.