CONTROL GP-JOYSTICK 2426207 - Caterpillar

Illustration 1 g01197302Open the cover of the storage box that is located on the right side in front of the fuel tank.The electric refueling pump (1) pumps fuel into the fuel tank.
Do not continuously operate the refueling pump for more than 30 minutes. Do not operate the refueling pump more than a few seconds without fuel. Pump damage can result.
On - Push switch (3) in order to activate the refueling pump.
Off - Push switch (4) in order to deactivate the refueling pump.
Remove cap (2) from the fuel tank.
Properly insert the free end of suction hose (5) into a container of fuel.
Push switch (3) in order to supply the fuel to the tank. When the tank is full, the pump stops refueling. Note: Look at level gauge (6) in order to determine the fuel level.
After refueling, install cap (2) to the fuel tank.
Make sure that excess fuel is drained from suction hose (5) before storing the suction hose.
When you store suction hose (5), wind the hose on the bar. Secure the hose end in place.
To prevent hose damage, do not coil the hose in a tight radius.
Close the cover of the storage box. Excavator with Demolition Cab (If Equipped)
A special washer reservoir is installed when a demolition cab is used.
Illustration 2 g00464509When a machine is equipped with a refueling pump and a demolition cab, the refueling pump is relocated under the exterior storage box.