CONTROL GP-UNPROGRAMMED 2437068 - Caterpillar

One-Piece Body
Illustration 1 g01156510
Two-Piece Body
Illustration 2 g01156511
(1) 242-3864 Spring Length under test force ... 43.18 mm (1.700 inch) Test force ... 43.7 N (9.8 lb) Free length after test ... 58.50 0.50 mm (2.303 0.020 inch) Outside diameter ... 11 mm (0.4 inch) (2) The oil filter bypass valves must open at the following pressure. ... 125 30 kPa (18 4 psi) (3) Hollow stud Before installing the hollow stud into the engine oil filter base, apply 154-9731 Thread Lock Compound to the tapered end of the hollow stud to a distance. ... 7.5 1.5 mm (0.30 0.06 inch) Torque ... 68 7 N m (50 5 lb ft) (4) Use clean engine oil to lubricate the oil filter's seal. Tighten the filter until the seal contacts the base. Hand tighten the filter for an additional 3/4 turn (270 degrees).
Illustration 3 g01449120
Torque sequence for the boltsNote: Use the tightening sequence that is shown in Illustration 3 in order to tighten the oil filter base assembly:
Tighten 15 bolts to 28 7 N m (21 5 lb ft).
Again, tighten 15 bolts to 28 7 N m (21 5 lb ft).