CONTROL AR-BACKHOE 2540153 - Caterpillar

Sounds
Sounds allows the operator to adjust various display sound settings.
Sounds IconTo open the Sounds screen, press the "Sounds" button. The "Sounds" button is situated to the right of the Units Icon, from the "System Settings" menu.
Illustration 47 g06225851
(1) System buzzer volume slider
(2) Volume test play button
(3) Above Grade on/off switch
(4) On Grade on/off switch
(5) Below Grade on/off switch
(6) Cancel button
(7) Done button
Table 38
Item Feature Description
1 System buzzer volume slider Raise and lower the system buzzer volume by pressing and holding the slider key and dragging it left (decrease volume) or right (increase volume).
2 Volume test play button Press to play a test sound to help judge the volume level.
3 Above Grade on/off switch Above Grade on/off switch is used to turn the audible signal that indicates being Above Grade off (switch set to the left) or on (switch set to the right).
4 On Grade on/off switch On Grade on/off switch is used to turn the audible signal that indicates being On Grade off (switch set to the left) or on (switch set to the right).
5 Below Grade on/off switch Below Grade on/off switch is used to turn the audible signal that indicates being Below Grade off (switch set to the left) or on (switch set to the right).
6 Cancel button Cancel button used to cancel changes made.
7 Done button Done button used to accept changes made. Display Brightness
Display Brightness is used to adjust the overall brightness of the display screen. The display brightness control is part of the standard Android firmware. Display brightness control can be accessed by a swipe down motion from the top of the screen starting within the Android firmware notification bar. The notification bar is found above the display interface at the top of the screen (a Wi-Fi connection icon will be seen on the right-hand side).Checking Bucket Wear
Attachments Screen
Over time, the bucket cutting edge will become worn which will cause changes in the cutting edge measurements. The changes in the cutting edge measurements caused by bucket wear must regularly be checked as part of machine maintenance or as instructed by the site supervisor. Follow the below steps to check or set the bucket wear compensation:
Measure the cutting edge length to the bucket wear control point. The bucket wear control point was defined when the bucket was first measured up.Note: If the bucket wears unevenly, use an average value. However, guidance will never be better than the range of the differences in cutting edge height.
From the Work Screen, tap the "Work Settings" button in the lower right corner of the display.
Illustration 48 g06225852
(1) Attachments option
Select the Attachments option (1) from "Work Settings" under the "Tools" section.Note: If the operator is updating the cutting edge measurement immediately after booting up the display, the operator must press the yellow "Start" button to enter the Work Screen.
Compare the cutting edge length on the display to the new measurement.
Illustration 49 g06239199
(2) Edit button
Tap the "Edit" button (2), if the existing measurement in the display does not match the new measurement.
The Attachments