CONTROL GP-FOOT BRAKE 2611317 - Caterpillar

When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 5 g01434253 (1) The slit of ring (1) must turn in the direction of the piston. (2) Apply Tooling (G) to the hole of ring (2) prior to installation. (3) Torque for locknut ... 5100 260 N m (3760 190 lb ft) (4) Apply Tooling (F) to the outer diameter and the inner diameter of seal (4). (5) Apply Tooling (F) to the outer diameter and the inner diameter of ring (5). (6) Apply Tooling (F) to the outer diameter and the inner diameter of ring (6). (7) Torque for head assembly ... 1100 110 N m (810 80 lb ft) (8) Apply Tooling (F) to the sealing lip of buffer seal (8). (9) Apply Tooling (F) to the sealing lip of seal (9). (10) Apply Tooling (E) to the groove of lip seal (10) prior to installation. Apply Tooling (F) to the sealing lip of lip seal (10). (11) Free movement of the stop after assembly ... 0.50 0.26 mm (0.020 0.010 inch) (12) Maximum out diameter of the retaining ring after assembly ... 53.30 mm (2.098 inch)Installation Procedure
Table 3
Required Tools
Tool Part Number Part Description Qty
A 188-3141 Work Stand 1
F 5P-0960 Grease Cartridge 1
Make sure that the pin bores in the stick cylinder, the boom, and the stick are clean and free of dirt prior to the installation of the stick cylinder.
Illustration 6 g01433562
Illustration 7 g01433580
Attach a suitable lifting device to stick cylinder (5). The weight of stick cylinder (5) is approximately 159 kg (350 lb). Position stick cylinder (5).
Apply Tooling (F) to the surface of pin assembly (9). Position stick cylinder (5) and install any shims that were present, pin assembly (9), and spacer (8). Install the washer and bolt (10).
Connect hose assemblies (6) and (7).
Illustration 8 g01433490
Lower stick cylinder (5) into position. Apply Tooling (F) to the surface of pin assembly (3). Install any shims that were present, pin assembly (3), and spacer (4). Install the washer and bolt (2).
Connect hose assembly (1).
Check the oil level in the hydraulic oil tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".
Remove Tooling (A).