CONTROL GP-STEERING CLUTCH 2695079 - Caterpillar

Removal Procedure
Illustration 1 g02793995
Remove oil drain plug (1). Drain the engine oil into a suitable container for storage or disposal.
Remove bolts (2). Remove engine oil pan (3).
Carefully separate engine oil pan (1) from the cylinder block.Note: Avoid damage to the engine oil pan during removal.Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Three Bond 1217H -
Ensure that the engine oil pan is clean and free from damage. Clean the mating surface of the cylinder block.
Illustration 2 g02793995
Illustration 3 g01347865
The pattern of application of sealant to the engine oil pan.
Apply a continuous bead of Tooling (A) to the mating surface of engine oil pan (3) inside the bolt holes. Refer to Illustration 3 for the correct pattern of application. The bead of Tooling (A) should be approximately 2 mm (0.080 inch) in diameter.
Ensure that bolts (4) are clean and dry.
Position engine oil pan (1) onto the cylinder block and install bolts (4).
Install a new sealing washer (2) to oil drain plug (3).
Install oil drain plug (3) to engine oil pan (1).
Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct draining and filling procedure.