CONTROL GP-VOLTAGE 2714055 - Caterpillar

start by:a) remove engine front support and timing gear coverb) remove camshaft 1. Remove four bolts (1) and plate (2). Remove front idler gear (3).2. Remove bearing from gear (3) with tooling (B) and a press. 3. Remove crankshaft gear (4) with tooling (A).Install Timing Gears
1. Install the bearing in front idler gear (1) with tooling (A) as shown. 2. Heat crankshaft gear (2) to a maximum temperature of 400°F (204°C). Install gear (2) with notch (4) in alignment with the pin on the crankshaft.3. Install gear (1). Make sure the "V" mark on gear (1) is in alignment with the "V" mark on gear (2).4. Install plate (3) with the groove towards gear (1). Install the four bolts that hold plate (3).end by:a) install camshaftb) install engine front support and timing gear cover