CONTROL GP-HANDLE 2854237 - Caterpillar

Illustration 8 g00489383
Remove nut (17) and remove wire (18) .
Illustration 9 g00489385
Remove clip (19) and remove pin (20) .
Loosen nut (21) and move the engine throttle cable aside.
Illustration 10 g00489386
Loosen hose clamp (22) .
Remove hose (23) .
Illustration 11 g00489387
Disconnect hose (24) .
Illustration 12 g00489391
Unhook battery terminals and remove the bolt and washer (25) .
Remove the battery bracket (26) .
Remove battery (27) .
Remove two bolts and remove electrical reset (28) .
Illustration 13 g00489449
Remove two bolts and washers (29) .
Remove two bolts and washers (30) . Remove the wires.
Remove plate assembly (31) .
Illustration 14 g00489455
Remove two bolts and washers (32) .
Remove two electrical clips (33) .
Illustration 15 g00489511
Disconnect two hoses (34) .
Loosen the hose clamp and remove hose (35) .
Illustration 16 g00489569
Remove nut (36) .
Remove the bolt and washer (37) .
Remove clip (38) .
Remove ground cable (39) .
Illustration 17 g00489577
Remove four nuts (40) and pull back the exhaust manifold.
Illustration 18 g00489579
Remove the bolt and washer (41) .
Remove electrical clip (42) .
Illustration 19 g00489661
Remove two nuts and two washers (43) .
Illustration 20 g00489663
Apply suitable lifting chains to the lifting points on the engine. Apply enough tension on the chains in order to support the weight of the engine.
Illustration 21 g00489665
Remove six bolts and washers (44) . The other three bolts are located on the rear of the engine.
Remove the engine and pumps. The weight of the engine and pumps is 125 kg (275 lb) .