2970295 CONTROL AR-AUXILIARY Caterpillar parts
320D LRR, 320D RR
Rating:
Alternative (cross code) number:
CA2970295
297-0295
2970295
CA2970295
297-0295
2970295
EXCAVATOR,
For full view, you need register
Information:
TYPE="LEVEL" DEPTH="1" @@@-->Type 1
Note: Use the 102-9720 Cleaning Kit. This product contains the detergent and oil that is made specifically for the maintenance of the air cleaner elements.
Illustration 1 g00887344
Note: This type of air cleaner element should be replaced after three cleanings.
Remove the air cleaner element (1). Tap the air cleaner element in order to dislodge dirt particles. Gently brush the air cleaner element with a soft bristle brush.
Do not use gasoline, steam, caustic or unapproved detergents, or parts cleaning solvents. Do not use high pressure water or air to clean the air cleaner element. Any of those liquids or methods can cause air cleaner element damage.
Spray the air cleaner element with the cleaning solution. Allow the air cleaner element to stand for 10 minutes.
Rinse the air cleaner element with low water pressure. The maximum water pressure for this procedure is 275 kPa (40 psi). Tap water is acceptable. Start to rinse the air cleaner element from the clean side (inside). Next, clean the dirty side (outside) in order to flush out dirt. Inspect the air cleaner element for tears and/or holes after the air cleaner element is cleaned. Do not reuse damaged air cleaner elements.
Do not use compressed air, open flame, or hot air to dry the air cleaner element. Excess heat shrinks cotton fiber, and compressed air may blow holes in the material. Allow the air cleaner element to air dry.
Shake excess water off the air cleaner element, and allow the air cleaner element to air dry. Drying the air cleaner element in the sun speeds the process.
Do not use transmission fluid, engine oil, diesel fuel, or other lubricant to oil the air cleaner element. The air cleaner element can not function correctly if improper oil is used. Never operate an engine with a dry air cleaner element. The air cleaner element can not function correctly without oil. Always saturate the clean air cleaner element with the recommended oil.
The dry air cleaner element should be oiled before installation. Apply small amounts of oil across the top of each pleat. Allow the oil to soak into the air cleaner element for 20 minutes. Oil any remaining "white" spots.
Inspect the housing and the clamp for air cleaner element (1). Install the clean, oiled air cleaner element. Replace the housing and the clamp, if necessary. Refer to Specifications, SENR3130, "Torque Specifications" for the proper torque of the clamp.Type 2
Illustration 2 g00888128
Disconnect latches (1) .
Remove cover (2) .
Remove air cleaner element (3) .Note: This type of air cleaner element may be cleaned up to six times.
Refer to Guideline for Reusable Parts and Salvage Operations, SEBF8062 for cleaning instructions or replace the air cleaner element.
Install the air cleaner element (3) .
Install cover (2) .
Fasten cover (2) with latches (1) .
Note: Use the 102-9720 Cleaning Kit. This product contains the detergent and oil that is made specifically for the maintenance of the air cleaner elements.
Illustration 1 g00887344
Note: This type of air cleaner element should be replaced after three cleanings.
Remove the air cleaner element (1). Tap the air cleaner element in order to dislodge dirt particles. Gently brush the air cleaner element with a soft bristle brush.
Do not use gasoline, steam, caustic or unapproved detergents, or parts cleaning solvents. Do not use high pressure water or air to clean the air cleaner element. Any of those liquids or methods can cause air cleaner element damage.
Spray the air cleaner element with the cleaning solution. Allow the air cleaner element to stand for 10 minutes.
Rinse the air cleaner element with low water pressure. The maximum water pressure for this procedure is 275 kPa (40 psi). Tap water is acceptable. Start to rinse the air cleaner element from the clean side (inside). Next, clean the dirty side (outside) in order to flush out dirt. Inspect the air cleaner element for tears and/or holes after the air cleaner element is cleaned. Do not reuse damaged air cleaner elements.
Do not use compressed air, open flame, or hot air to dry the air cleaner element. Excess heat shrinks cotton fiber, and compressed air may blow holes in the material. Allow the air cleaner element to air dry.
Shake excess water off the air cleaner element, and allow the air cleaner element to air dry. Drying the air cleaner element in the sun speeds the process.
Do not use transmission fluid, engine oil, diesel fuel, or other lubricant to oil the air cleaner element. The air cleaner element can not function correctly if improper oil is used. Never operate an engine with a dry air cleaner element. The air cleaner element can not function correctly without oil. Always saturate the clean air cleaner element with the recommended oil.
The dry air cleaner element should be oiled before installation. Apply small amounts of oil across the top of each pleat. Allow the oil to soak into the air cleaner element for 20 minutes. Oil any remaining "white" spots.
Inspect the housing and the clamp for air cleaner element (1). Install the clean, oiled air cleaner element. Replace the housing and the clamp, if necessary. Refer to Specifications, SENR3130, "Torque Specifications" for the proper torque of the clamp.Type 2
Illustration 2 g00888128
Disconnect latches (1) .
Remove cover (2) .
Remove air cleaner element (3) .Note: This type of air cleaner element may be cleaned up to six times.
Refer to Guideline for Reusable Parts and Salvage Operations, SEBF8062 for cleaning instructions or replace the air cleaner element.
Install the air cleaner element (3) .
Install cover (2) .
Fasten cover (2) with latches (1) .
Caterpillar SIS machinery equipment:
Parts control Caterpillar catalog:
3350344
CONTROL AR-AUXILIARY
320D RR
320D RR
3503303
CONTROL AR-AUXILIARY
320D RR
320D RR
3503304
CONTROL AR-AUXILIARY
320D RR
320D RR
3503338
CONTROL AR-AUXILIARY
320D LRR
320D LRR
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312E, 312E L, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D L, 316E L, 318D2 L, 318E L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D L, 320D LRR, 320D RR, 320D2 L, ...
120K, 120K 2, 120M, 120M 2, 12K, 12M, 12M 2, 140K, 140K 2, 140M, 140M 2, 14M, 160K, 160M, 160M 2, 16M, 2384C, 2470C, 2484C, 24M, 2570C, 2670C, 2864C, 311D LRR, 312C, 312C L, 312D, 312D L, 312D2, 312D2...
120M, 12M, 2470C, 311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D...
0969506
CONTROL
318C, 319C, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320C L, 320D, 320D LRR, 321C, 323D L, 323D LN
318C, 319C, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320C L, 320D, 320D LRR, 321C, 323D L, 323D LN
307D, 308D, 311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 315D L, 318D L, 318D2 L, 319D L, 319D LN, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 32...
2457832
CONTROL AS
307D, 311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315D L, 318D L, 318D2 L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR,...
307D, 311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315D L, 318D L, 318D2 L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR,...
308D, 312D, 315D L, 319D, 319D LN, 320D FM RR, 320D L, 320D LRR, 323D L, 323D LN, 324D L, 325D L, 329D L, 330D L, 345C
2974595
CONTROL GP-HANDLE
311D LRR, 312D, 312D L, 314D CR, 314D LCR, 315D L, 319D, 319D L, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321D LCR, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325D, 325D L, 328D LCR, 329D, 329D...
311D LRR, 312D, 312D L, 314D CR, 314D LCR, 315D L, 319D, 319D L, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321D LCR, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325D, 325D L, 328D LCR, 329D, 329D...
6K7602
CONTROL GP-HAND
920, 930, 930R
920, 930, 930R
2072373
CONTROL GP-TRANSMISSION HYD
D6R II, D7R II, D8R II
D6R II, D7R II, D8R II
1362238
CONTROL GP-TRACTION ELECTRONIC
768C, 769C, 769D, 771C, 771D, 773B, 773D, 775B, 775D, 776C, 776D, 777D, 784B, 785B, 789B, 793B, 793C
768C, 769C, 769D, 771C, 771D, 773B, 773D, 775B, 775D, 776C, 776D, 777D, 784B, 785B, 789B, 793B, 793C
1609146
CONTROL & MTG GP-COMMUNICATION
561N, D5N, D6N
561N, D5N, D6N
1607753
CONTROL GP-PARKING BRAKE
120H, 12H, 135H, 140H, 143H, 160H, 163H
120H, 12H, 135H, 140H, 143H, 160H, 163H
9D4110
CONTROL GP-HOIST
768C, 769C, 772B, 773B, 776, 777, 777B
768C, 769C, 772B, 773B, 776, 777, 777B
2083915
CONTROL GP-ELECTROHYDRAULIC
950G II, 962G II, 966G II, 972G II, 980G II, 980H
950G II, 962G II, 966G II, 972G II, 980G II, 980H
1284110
CONTROL GP-FUEL RATIO
3406B, 3406C, PM-465, RM-250C, RM-350B, RR-250B, SM-350
3406B, 3406C, PM-465, RM-250C, RM-350B, RR-250B, SM-350