3065989 CONTROL GP-HANDLE Caterpillar parts
307D, 308D
Rating:
Alternative (cross code) number:
CA3065989
306-5989
3065989
CA3065989
306-5989
3065989
Weight: 0.75 pounds 0 kg.
MINI HYD EXCAVATOR,
This part in 7 request:
Show.
This information for suppliers only!
2023-12-15
2022-07-22
2022-05-02
2022-04-26
2020-08-07
2020-08-03
2018-12-29
Number on catalog scheme:
4
For full view, you need register
Information:
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Note: If the sulfur content in the fuel is greater than 1.5% by weight, use an oil that has a TBN of 30 and reduce the oil change interval by one-half.Park the machine on a level surface and engage the parking brake. Stop the engine.Note: Drain the crankcase while the oil is warm. Warm oil allows waste particles that are suspended in the oil to drain. As the oil cools, the waste particles will settle to the bottom of the crankcase. The particles will not be removed by draining the oil and the particles will recirculate in the engine lubrication system with the new oil.
Illustration 1 g06207919
The drain valve for the engine crankcase oil is located under the rear of the upper structure.Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
Illustration 2 g03477497
Open the crankcase drain valve. Allow the oil to drain into a suitable container.Note: Discard any drained fluids according to local regulations.
Close the drain valve.
Open the access door on the right side of the machine.
Illustration 3 g03674429
Remove the oil filter. See Operation and Maintenance Manual, "Oil Filter - Inspect". Discard the used oil filter properly.
Clean the filter housing base. Make sure that all the former filter gasket is removed.
Apply a thin coat of engine oil to the gasket of the new filter.
Install the new oil filter by hand.Instructions for the installation of the filter are printed on the side of each Caterpillar spin-on filter. For non-Caterpillar filters, refer to the installation instructions that are provided by the supplier of the filter.
Illustration 4 g03674390
(1) Dipstick
(2) Oil Filler cap
Remove oil filler cap (2). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)" and Operation and Maintenance Manual, "Lubricant Viscosities". Clean the oil filler cap and install the oil filler cap.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Start the engine and allow the oil to warm. Check the engine for leaks. Stop the engine.
Illustration 5 g00104116
Wait for 30 minutes to allow the oil to drain back into the crankcase. Check the oil level with dipstick (1). Maintain the oil between the "H" and "L" marks on the dipstick. If necessary, add oil.
Close the access door.
Caterpillar parts catalog:
Parts control Caterpillar catalog:
2602173
CONTROL GP-UNPRGMED MONITOR
308D, 314D LCR, 321D LCR, 328D LCR, 345C
308D, 314D LCR, 321D LCR, 328D LCR, 345C
3147333
CONTROL GP-JOYSTICK
307D, 308D
307D, 308D
3105627
CONTROL & MTG GP-JOYSTICK
307D, 308D
307D, 308D
3121627
CONTROL GP-HANDLE
307D, 308D
307D, 308D
3108305
CONTROL & MTG GP-JOYSTICK
307D, 308D
307D, 308D
3108304
CONTROL GP-PILOT OPERATED HYD
307D, 308D
307D, 308D
307D, 308D, 311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 315D L, 318D L, 318D2 L, 319D L, 319D LN, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 32...
3121444
CONTROL GP-HANDLE
307D, 308D
307D, 308D
2457832
CONTROL AS
307D, 311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315D L, 318D L, 318D2 L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR,...
307D, 311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315D L, 318D L, 318D2 L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR,...
307D, 308D, 311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 315D L, 318D L, 318D2 L, 319D L, 319D LN, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 32...
3197233
CONTROL GP-HANDLE
303.5C, 303C CR, 304C CR
303.5C, 303C CR, 304C CR
3197232
CONTROL GP-HANDLE
303.5C, 303C CR, 304C CR
303.5C, 303C CR, 304C CR
2663217
CONTROL GP-HANDLE
302.5C, 303.5C, 303C CR, 304C CR, 305C CR
302.5C, 303.5C, 303C CR, 304C CR, 305C CR
3125848
CONTROL GP-SWITCH
M318D MH, M322D MH
M318D MH, M322D MH
2974595
CONTROL GP-HANDLE
311D LRR, 312D, 312D L, 314D CR, 314D LCR, 315D L, 319D, 319D L, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321D LCR, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325D, 325D L, 328D LCR, 329D, 329D...
311D LRR, 312D, 312D L, 314D CR, 314D LCR, 315D L, 319D, 319D L, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321D LCR, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325D, 325D L, 328D LCR, 329D, 329D...
3564944
CONTROL AS-FAN
308D, 312E, 312E L, 314D CR, 314D LCR, 316E L, 318E L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 323E L, 324E, 324E L, 324E LN, 328D LCR, 329E, 329E L, 329E LN, 336E, 336E H, 336E HVG, 336E ...
308D, 312E, 312E L, 314D CR, 314D LCR, 316E L, 318E L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 323E L, 324E, 324E L, 324E LN, 328D LCR, 329E, 329E L, 329E LN, 336E, 336E H, 336E HVG, 336E ...
308D, 312D, 315D L, 319D, 319D LN, 320D FM RR, 320D L, 320D LRR, 323D L, 323D LN, 324D L, 325D L, 329D L, 330D L, 345C
3065987
CONTROL GP-HANDLE
307D, 308D
307D, 308D
3065988
CONTROL GP-HANDLE
307D, 308D
307D, 308D