CONTROL & MTG GP-JOYSTICK 3100365 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     6V-3069     Alignment Tool     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Lubricate O-ring seals with the lubricant that is being sealed.
Illustration 1 g00531820
Illustration 2 g00531650
Illustration 3 g00531653
Position spider (14) on the shaft in the center of the flywheel. Soak two friction discs (10) in SAE 10W oil for at least one hour before installation. Install two friction discs (10) and two discs (9) to the housing in alternating order. Align the splines in the friction discs with the splines in the spider. Begin with a friction disc and end with a disc.
Install plate assembly (8) , spring disc (7) , and retainer (6) to the housing.
Install three bolts (5) and the washers that secure retainer (6) to the housing. Do not tighten bolts at this time.
Use Tooling (A) to center spider (14) , the discs, and the plate assembly in the flywheel housing.
Install remaining 21 bolts (5) that secure retainer (6) to the housing. Tighten 24 bolts (5) to a torque of 56 7 N m (41 5 lb ft). Remove the tooling.
Illustration 4 g00532483
Remove spider (14) from the flywheel housing. Position spider (14) to shaft (15) in the retarder.
Illustration 5 g00531652
Install two bolts (12) and the washers that secure retainer (13) and spider (14) to the shaft.
Illustration 6 g00531651
Install O-ring seal (11) to retarder (1) .
Illustration 7 g00531647
Use a hoist to position retarder (1) to the flywheel housing. Install 12 bolts (4) that secure retarder (1) to the engine. Tighten the bolts to a torque of 50 7 N m (37 5 lb ft). Remove the tooling.
Illustration 8 g00531648
Install bolt (2) and the washer that secures the clip and hose (3) to the retarder., End By: Install the engine. Refer to Disassembly and AssemblyRENR1461, "Engine - Install".