CONTROL GP-HANDLE 3285932 - Caterpillar

Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     9S-9100     Sling Assembly     1    Start By:
For machines without a cab, remove the support and the seat group. Refer to Disassembly and Assembly, "Seat Support - Remove". For machines with a cab, tilt the cab toward the back.
For machines without a cab, remove the universal joint. Refer to Disassembly and Assembly, "Universal Joint - Remove and Install". For machines with a cab, remove the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove".
For machines without a cab, remove the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove". For machines with a cab, remove the universal joint. Refer to Disassembly and Assembly, "Universal Joint - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the oil from the bevel gear case and the transmission.
Illustration 1 g00347654
Remove tube assembly (1) from the transmission oil cooler to the transmission. Remove tube assembly (2) and hose assembly (3). Remove tube assembly (4). Remove tube assembly (5) and tube assembly (6) .
Illustration 2 g00347655
Remove clip (7). Remove magnetic screen (8). Remove clip (9) and move heater hoses away from the top of the transmission.
Disconnect the wiring from the directional switch that is for forward and reverse.
Remove interlock linkage (10) .
Illustration 3 g00347656
Remove two of the bolts that hold the top cover in position on the transmission. Install two 3/8" - 16 NC forged eyebolts in the bolt holes. Fasten tool (A) and a hoist to the transmission.
Remove nuts (11) that hold the transmission to the bevel gear case.
Illustration 4 g00333679
Install two 1/2" - 13 NC forcing screws in the transmission case. Tighten the screws evenly in order to make a separation of the transmission from the bevel gear case.
Illustration 5 g00333718
Remove transmission (12) from the bevel gear case. In order to remove the transmission from the machine, make any necessary adjustments to tool (A). The weight of the transmission is 225 kg (500 lb).
Illustration 6 g00333738
Remove wiring harness (13) .
Remove three