CONTROL GP-GENERATOR SET 3512429 - Caterpillar

whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Recycle
Battery or Battery Cable - Disconnect
Coolant Extender (ELC) - Add
Film (Product Identification) - Clean
Fuel System - Prime
Generator Bearing - Lubricate
Generator Load - Check
Generator Set - Test
Every Week
Automatic Start/Stop - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator - Inspect
Generator Bearing Temperature - Test/Record
Jacket Water Heater - Check
Power Factor - Check
Standby Generator Set Maintenance Recommendations
Voltage and Frequency - Check
Walk-Around Inspection
Overhaul
Generator Bearing - Replace
Overhaul Considerations
Every 250 Service Hours
Engine Oil and Filter - Change
Every 6 Months
Coolant Sample (Level 1) - Obtain
Generator Lead (Round Cable) - Check
Every Year
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Performance - Test
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Generator Set Vibration - Inspect
Generator Set Vibration - Test/Record
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Rotating Rectifier - Check
Starting Motor - Inspect
Stator Lead - Check
Varistor - Check
Varistor - Inspect
Water Pump - Inspect
Every 3 Years
Coolant (DEAC) - Change
Coolant (ELC) - Change
Coolant Temperature Regulator - Replace
Ether Starting Aid Cylinder - Replace
Turbocharger - Inspect
Commissioning
Generator Set Alignment - Check