CONTROL GP- 3518752 - Caterpillar

Illustration 13 g03634205
When the "Main Pump Flow Limit" option is highlighted, press OK key (3).
Illustration 14 g03634206
After the OK key is pressed the "Main Pump Flow Limit" menu will appear. From this menu, the following options are available:
"Flow Limit Press"
"2 Pump Flow"
"1 Pump (Pump #1)"
"1 Pump (Pump #2)"Refer to Illustration 14.
From the "Main Pump Flow Limit" menu, highlight the "Flow Limit Press" option. When "Flow Limit Press" option is highlighted, press OK key (3).
Illustration 15 g03634639
Illustration 16 displays the current value of pump 1 and pump 2.
Use the Up and Down arrows to scroll through the pump pressures during the calibration.
Illustration 16 g03634714
Operate the joystick to the STICK IN position. When the stick is in the STICK IN position, the hydraulic cylinder that controls the stick will be fully extended. Press the OK key (3).
Illustration 17 g03634720
After the OK key is pressed, resume operation of the joystick to the STICK IN position. Hold the stick in the STICK IN position during the calibration.
Illustration 18 g03634727
While the stick is in the STICK IN position, activate the work tool. Observe the pressure on the gauge.
Use the left key (7) or the right key (5) to adjust the current level. Tune the machine to the "LOW PRESSURE" value that is located under "TARGET VALUE" that is found in table 2.
When the desired value is achieved, press the OK key (8). The monitor will automatically begin the steps that are necessary to calibrate the "MAX" flow.
Illustration 19 g03634977
Move the joystick to the STICK IN position. When the stick is in the STICK IN position, the hydraulic cylinder which controls the stick will be fully extended. Press the OK key (3).
After the OK key is pressed, resume operation of the joystick to the STICK IN position. Hold the stick in the STICK IN position during the calibration.
Illustration 20 g03634737
While the stick is in the STICK IN position, activate the work tool. Observe the pressure on the gauge.
Use the left key (7) or the right key (5) to adjust the current level. Tune the pressure to the "HIGH PRESSURE" value that is located under "TARGET VALUE" that is found in Table 2.
Illustration 21 g03634738
When the desired value is achieved, press the OK key (8). After the OK key is pressed, the monitor will automatically display the "SUCCEEDED" screen.
After completion of the calibration, press the cancel key (7) in order to exit the program.
It is possible for an error to occur during the calibration of the monitor. In case an error occurs, a screen with active errors will appear. If a screen of errors should appear, the calibration will fail and any set values that were achieved will be lost. Recalibrate the monitor. Refer to Table 4 for examples of possible errors.
Table 4
Error Description of Event
$0001 ECM Fault
$0002 Active Diagnostic Present
$0003 Another Calibration is Active
$0004 Calibration Active by Another ECM
$0005 Loss of Calibration Interlock
$0006 Calibration Aborted by Tool/Monitor
$0007 Requested Display Not Supported
$0008 Unavailable Display
$0009 Calibration Aborted by ECM
$000A Calibration Failure
$000B Calibration Not Supported
$0100 Out-of-Range Low - Incr/Decr Parameter
$0101 Out-of-Range High - Incr/Decr Parameter
$0102 Invalid