CONTROL & MTG GP-JOYSTICK 3579151 - Caterpillar

TYPE="TABLE" @@@-->
Illustration 1 g01025099
The bolts that are marked "X" are 216 mm (8.5 inch) long. The lengths of the remaining bolts are 194 mm (7.6 inch) long.Apply 6V-4876 Lubricant to the bolt threads and both sides of the washers. Tighten the bolts in the following step sequence:
In a numerical sequence, tighten bolts 1 through 26.Torque for bolts ... 270 15 N m (200 11 lb ft)
In a numerical sequence, tighten bolts 1 through 26.Torque for bolts ... 450 15 N m (330 11 lb ft)
In a numerical sequence, again tighten bolts 1 through 26.Torque for bolts ... 450 15 N m (330 11 lb ft)Note: The flatness of the cylinder head should be within a total of 0.13 mm (.005 inch). Also, the flatness of the cylinder head should be within a maximum of 0.05 mm (.002 inch) for any 150 mm (6.0 inch) span.
Illustration 2 g01322887
(A) Cylinder Head Thickness Thickness of a new cylinder head ... 120.00 0.15 mm (4.724 0.006 inch) Minimum thickness of a used cylinder head ... 119.50 mm (4.705 inch)
Illustration 3 g01322895
(27) Oil gallery (28) Bearing joint (29) Oil holes (30) Camshaft bearing
Camshaft bearings must be installed into their correct position. Failure to do so will result in engine damage.
Illustration 4 g01323077
(B) Orientation of bearing joint (C) Diameter of Camshaft Bore (31) Bearing jointOrientation of bearing joint (B) ... 20° 5° above horizontal (C) Diameter of camshaft bore ... 90.985 0.020 mm (3.5821 0.0008 inch)
Illustration 5 g01520165
The depth of installation of the sleeve bearings is important. Install sleeve bearings (4) to the following depths: Dimension (D) ... 8.0 0.5 mm (0.31 0.02 inch) Dimension (E) ... 178.1 0.5 mm (7.01 0.02 inch) Dimension (F) ... 349.5 0.5 mm (13.76 0.02 inch) Dimension (G) ... 521.0 0.5 mm (20.51 0.02 inch) Dimension (H) ... 692.4 0.5 mm (27.26 0.02 inch) Dimension (J) ... 863.8 0.5 mm (34.01 0.02 inch) Dimension (K) ... 1035.3 0.5 mm (40.76 0.02 inch)