CONTROL GP-HANDLE 3616015 - Caterpillar

Installation Procedure For Seals 113-8432 and 113-8433
Table 1
Required Tools
Tool Part Number Part Description Qty
D 6V-4003 (1) Seal Locator As 1
2N-5006 (1) Bolt 2
E 8T-3099 (1) Seal Installer 1
F 9S-8858 (1) Nut 1
G - Loctite 7649 Primer N 1
H - Loctite 620 Retaining Compound 1
J 452-6011 Multipurpose Grease 1
K 484-7863 (2) Tool As 1
(1) For installation of seals 113-8432 and 113-8433
(2) For Installation of seals 436-1478 and 436-1479
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Every time that the crankshaft seal is removed from the wear sleeve, a new wear sleeve and crankshaft seal must be installed.
Illustration 1 g01005029
Illustration 2 g01207497
Attach Tooling (D) to the crankshaft.
Clean the outer diameter of the crankshaft and the inner diameter of the new wear sleeve with Tooling (G).
Apply Tooling (H) to the outer diameter of the crankshaft and the inner diameter of the new wear sleeve.
If the crankshaft seal and the wear sleeve come apart during installation, the crankshaft seal and the wear sleeve must be replaced.
Note: The front crankshaft seal and the wear sleeve cannot be interchanged with the rear crankshaft seal and the wear sleeve.
Do not place engine oil on the crankshaft seal for installation. Lubrication of the crankshaft seal can give a false indication of leakage at a later time.
Illustration 3 g01207499
Place front seal (1) and wear sleeve (2) onto Tooling (D).
Illustration 4 g01051474
Illustration 5 g01005047
Place Tooling (E) onto Tooling (D). Apply Tooling (J) onto the face of the washer on Tooling (F). Install Tooling (F) onto Tooling (E). Tighten the nut until Tooling (E) contacts Tooling (D).
Remove the Tooling from the crankshaft.Installation Procedure For Seals 436-1478 and 436-1479