CONTROL GP-HANDLE 3798403 - Caterpillar

Illustration 6 g00554478
The fuel tank has been removed for photographic clarity.
Remove three bolts (9) and the washers that secure brake oil cooler (5) to the engine.
Illustration 7 g00551716
Attach lifting straps and a hoist to brake oil cooler (5) .
Illustration 8 g00551714
Remove six bolts (10) that secure brake oil cooler (5) to bonnet (11). Remove the brake oil cooler from the machine. The weight of the brake oil cooler is 27 kg (60 lb).
Illustration 9 g00552219
If necessary, remove the six bolts that secure the bonnet to brake oil cooler (5) and remove the bonnet. Remove the gaskets. Use an appropriate sized dowel rod in order to clean coolant tubes (12) in the cooler.Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
If necessary, place the bonnet and the gasket into position. Install the six bolts that secure the bonnet to the brake oil cooler.
Illustration 10 g00554474
Attach lifting straps and a hoist to brake oil cooler (5). Place the brake oil cooler into position. The weight of the brake oil cooler is 27 kg (60 lb).
Illustration 11 g00551714
Install six bolts (10) that secure brake oil cooler (5) to bonnet (11) .
Illustration 12 g00554478
The fuel tank has been removed for photographic clarity.
Install three bolts (9) and the washers that secure the brake oil cooler to the engine.
Illustration 13 g00551589
The fuel tank has been removed for photographic clarity.
Install O-rings onto two brake lines (8). Position the brake lines and install eight bolts (6), the washers and four half clamps (7) that secure the brake lines to the brake oil cooler.
Illustration 14 g00551679
The fuel tank has been removed for photographic clarity.
Install drain plug (4) and the washer to brake oil cooler (5) .Note: Apply 1U-8846 Sealant around the washer in order to improve the seal.
Illustration 15 g00551711
Place the exhaust pipe into position. Install two bolts (2), the washers and the nuts that secure the exhaust pipe to the exhaust support bracket.
Illustration 16 g00551680
Install four bolts (1) and the nuts onto the exhaust pipe assembly.
Illustration 17 g00551701
The turbocharger shield has been removed for photographic clarity.
Install clamp (3) that secures the exhaust pipe to the turbocharger.
Refill the cooling system with coolant. Refer to Operation and Maintenance Manual, SEBU7183 for the proper procedure.
Check the level of the hydraulic fluid. Refer to Operation and Maintenance Manual, SEBU7183 for the proper procedure.
Check the system for leaks.