CONTROL GP-TRANSMISSION HYD 3T1510 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Removal Procedure
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03717213
Illustration 2 g03717216
Remove caps (3) from nuts (4) (not shown).
Remove nuts (4) (not shown) and washers (2) from cover (1).
Remove cover (1).
Removal fuel injection lines (5) and fuel injection line (6). Refer to Disassembly and Assembly, "Fuel Injection Lines (Non M.C.S. Fuel Injection Lines) - Remove and Install" for the correct procedure.
Illustration 3 g03717218
Illustration 4 g03717251
Disconnect harness assembly (7) from fuel pressure sensor (8).
Remove banjo bolt (14) from tube assembly (13). Remove sealing washers (12) (not shown).
Remove bolts (9) and self locking nuts from fuel manifold (10). Remove the fuel manifold from bracket (11).
If necessary, remove fuel pressure relief valve (15) from fuel manifold (10). Refer to Disassembly and Assembly, "Fuel Pressure Relief Valve (Fuel Manifold Pressure Relief Valve) - Remove and Install" for the correct procedure. Installation Procedure
Ensure that the fuel manifold is free from wear or damage. If any part of the fuel manifold is worn or damaged, the fuel rail must be replaced as an assembly.
Illustration 5 g03717251
Illustration 6 g03717218
If necessary, install fuel pressure relief valve (15) to fuel manifold (10). Refer to Disassembly and Assembly, "Fuel Pressure Relief Valve (Fuel Manifold Pressure Relief Valve) - Remove and Install" for the correct procedure.
Position fuel manifold (10) onto bracket (11). Install bolts (9) and the self locking nuts hand tight.
Install a new sealing washer (12) (not shown) to banjo bolt (14). Install the banjo bolt to tube assembly (13) and install remaining new sealing washer (12) the banjo bolt. Tighten banjo bolt to a torque of 15 N m (133 lb in).
Connect harness assembly (7) to fuel pressure sensor (8).
Illustration 7 g03717213
Illustration 8 g03717216
Install new set of fuel injection lines (5) and a new fuel injection line (6). Refer to Disassembly and Assembly, "Fuel Injection Lines (Non M.C.S. Fuel Injection Lines) - Remove and Install" for the correct procedure. Note: Tightening of the bolts and the self locking nuts for the fuel manifold is completed in