CONTROL & MTG GP-ENGINE ELEK 4176017 - Caterpillar

Note: The FLOAT position is the normal operating position for cutting operation.Rotor Service Door Closing Indicator (10)
Rotor Service Door Closing Indicator - When the rotor inspection enable key switch is ON, and the rotor service door is open, the rotor service door closing indicator will illuminate when closing the rotor service door.Rotor Service Door Lock Release Knob (11)
Rotor Service Door Lock Release Knob - Pull on the knob in order to release the lock on the rotor service door to allow the door to close.Connector Socket (12)
Connector Socket - The 24 V power socket can be used to power auxiliary electrical equipment.Secondary Conveyor Control Lever (13)
Secondary Conveyor Control Lever - Moves the secondary conveyor right, left, up or down.
Lower - Move the lever upward to lower secondary conveyor.
Raise - Move the lever downward to raise the secondary conveyor.
Left - Move the lever to the left to move the secondary conveyor to the left.
Right - Move the lever to the right to move the secondary conveyor to the right.Machine Speed Control (14)
Machine Speed Control - Sets the maximum propel speed of the machine. Turn the speed dial fully clockwise to operate the propel system at maximum speed. Turn the speed dial fully counterclockwise to operate the machine at the minimum speed.On/Stand-by Switch (15)
Automatic - The ON/STAND-BY Switch puts the machine into STAND-BY mode. The ON/STAND-BY Switch puts the machine into AUTOMATIC OPERATION MODE.
STAND-BY - Move the Switch forward to put the machine in STAND-BY mode. When the machine is set to stand-by, the propel system and the conveyors stop, and the engine rpm drops.Note: When the machine is placed in STAND-BY, the following automatic functions are stopped until the switch is returned to ON:
Traction
Conveyors
Water Spray
Leveling System
ON - Move the switch rearward to return the machine to AUTOMATIC operation. The machine will return to operation at the current control settings.Left Rear Elevation Control Switch (16)
Left Rear Elevation Control Switch - Raises and Lowers the left rear of the machine.
Raise - Move the switch forward to RAISE the left rear of the machine.
Lower - Move the switch to the rear to LOWER the left rear of the machine.Right Rear Elevation Control Switch (17)
Right Rear Elevation Control Switch - Raises and Lowers the right rear of the machine.
Raise - Move the switch forward to RAISE the right rear of the machine.
Lower - Move the switch to the rear to LOWER the right rear of the machine.Propel Lever (18)
Propel Lever - Controls the forward and reverse propel speed of the machine. To move the lever out of NEUTRAL position, lift and hold the lock located under the propel lever knob and move the propel lever. When the propel lever is in the propelling range, release the lock.Forward - Move the propel lever forward in order to propel the machine in the forward direction. The farther the lever is moved, the faster the machine will move.Neutral - Move the propel lever to the center position to stop the machine. After the machine comes to