CONTROL GP-GENERATOR SET 4509596 - Caterpillar

Illustration 56 g00960295
Install springs (18) and plate (17) .
Illustration 57 g01228395
Illustration 58 g00960293
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Use a suitable press and Tooling (C) in order to install ring (16) .
Illustration 59 g00960289
Install retaining ring (14) and seals (15) onto housing assembly (13). Lubricate seals (15) with the lubricant that is being sealed.
Illustration 60 g01228398
Attach Tooling (E) and a suitable lifting device to housing assembly (13) .
Position housing assembly (13) .
Use Tooling (B) in order to compress retaining ring (14). Install housing assembly (13) .
Illustration 61 g00960286
Install seals (12) onto piston (11). Lubricate seals (12) with the lubricant that is being sealed.
Illustration 62 g00960283
Install piston (11) .
Illustration 63 g00960282
Install springs (8), discs (9), and plates (10) .
Illustration 64 g00960281
Install bearing (7) and ring (6) into housing (5) .
Illustration 65 g00960280
Install housing (5) and bolts (4). Tighten bolts (4) to a torque of 111 11 N m (82 8 lb ft).
Illustration 66 g00960279
Use Tooling (A) in order to install retaining ring (3) .
Illustration 67 g00960277
Install sensors (1) to a distance of 0.71 0.18 mm (0.028 0.007 inch) from the gear.
Tighten nuts (2) to a torque of 25 5 N m (18 4 lb ft).
Illustration 68 g00970309
Position transmission hydraulic control valve (1B) .
Install four bolts (1A). Tighten bolts (1A) to a torque of 25 5 N m (221.0 44.0 lb in).End By: Connect the transmission and bevel gear.