CONTROL GP-TRANSMISSION HYD 4548722 - Caterpillar

Procedure for the Installation of the New Oil Pan Gasket
Note: Some Machines that are listed above may not have the plate located between the oil pan and the engine block. In these instances, only one replacement oil pan gasket will be used. The installation procedure of the gasket remains the same and the Steps involving the plate are not used.
Table 1
Required Parts    
Qty     Part Number     Part Description    
1     141-5831     Silicone Sealant    
1     1Y-3904     Adhesive    
6     1A-2029     Bolts    
6     5M-2894     Hard Washers    
1 or 2 (1)     353-5065     Oil Pan Gasket    
( 1 ) Some Machines that are listed above may not have the plate located between the oil pan and the engine block. In these instances, only one replacement oil pan gasket will be used.
Drain the engine oil into a suitable container.
Remove the bolts with washers that secure the engine oil pan to the engine block.
Remove the engine oil pan.
Remove the suction tube, bracket, and discharge tube.
Remove the plate with both of the gaskets that are located on both sides of the plate.
Clean the sealing surface of the oil pan, plate, and engine block thoroughly.
Illustration 1 g02476831
Location of the adhesive on the plate (1) Plate
Apply 1Y-3904 Adhesive onto the side of the plate that will contact the engine block. Refer to Illustration 1 for the proper location of the adhesive.
Illustration 2 g02476897
Location of sealant at the joints of the gasket (2) 141-5831 Silicone Sealant
Install one of the new gaskets onto the side of the plate that will contact the engine block. Apply 141-5831 Silicone Sealant at the puzzle joints of the new gasket. Refer to Illustration 2 for the proper location of the sealant.
Illustration 3 g02477451
(A) Location of T-joints
Apply a 3 mm (0.11811 inch) to 5 mm (0.19685 inch) bead of 141-5831 Silicone Sealant at the T-joints of the engine block. Refer to Illustration 4 for the proper location of the sealant.Note: All of the joints must be assembled within 10 minutes of sealant application. After 10 minutes the sealant will begin to harden, and the performance of the sealant is compromised.
Illustration 4 g02477309
(3) 1A-2029 Bolt (4) 5M-2894 Hard Washer
Install plate with gasket onto the engine block. Use location 1 and 2, 3 and 4, or 5 and 6 with bolts (3) with washers (4) for installation.
Install the suction tube, brackets, and discharge tube.
Illustration 5 g02477177
Typical exampleLocation of sealant at the joints of the gasket
Install the new gasket onto the engine oil pan.
Install the engine oil pan with the new gasket onto the engine block. Use the bolts and the washers that were removed in Step 2.
Illustration 6 g02477317
Tighten the bolts 1 through 40 to the following torque: 40 5 N m (30 4 lb ft). Refer to Illustration 6 for the proper tightening sequence.
Illustration 7 g02477373
Retighten bolts 1 through 40 to the following torque: 47 5 N m (35 4 lb ft). Refer to Illustration