CONTROL GP-JOYSTICK 4574647 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Gp 1
B 289-2838 Spanner 1
289-2846 Spanner Wrench 1
D - Loctite 609 -
Illustration 1 g01354899
Raise temperature of bearing cone (20) and lower temperature of gear (19). Install bearing cone (20).
Illustration 2 g01354903
Lower the temperature of bearing cups (21) and (22). Install bearing cups (21) and (22).
Illustration 3 g01354888
Lower the temperature of gear (19) and raise the temperature of bearing cone (18). Position manifold (5) on gear (19). Install bearing cone (18). Position lock (16). Install nut (17) and tighten hand tight.
Illustration 4 g01354874
Install bearing cone (14) onto carrier (15).
Illustration 5 g01354737
Lower the temperature of bearing cups (12) and (13). Install bearing cups (12) and (13) into gear (11).
Illustration 6 g02169653
Position gear (11) onto carrier (15). Install bearing cone (10). Install retaining ring (9).
Illustration 7 g01231873
Install seal (8).
Illustration 8 g01231872
Install O-ring seals (7).
Illustration 9 g01231871
Install carrier assembly (6) into manifold (5).
Illustration 10 g01231869
Lower the temperature of race (4). Apply Tooling (D) evenly onto the mating surfaces of race (4) and manifold (2). Use Tooling (A) to install race (4) into manifold (2).
Illustration 11 g01231868
Position manifold (2). Install bolts (1). Install bolt (3). Do not torque bolts (1) and bolt (3) at this time.
Ensure that bearing cone (10) and bearing cone (18) rotate freely. End By:
Install the pump drive. Refer to Disassembly and Assembly, " Pump Drive - Install".