CONTROL GP-JOYSTICK 4582080 - Caterpillar

Removal Procedure
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Disconnect the battery.
Illustration 1 g02500079
Place an index mark on all of the harness assemblies. Disconnect the harness assemblies from electric starting motor (2).
Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately 30 kg (66 lb).
Remove bolts (1).
Remove electric starting motor (2) and the gasket from the flywheel housing. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install a new gasket on the electric starting motor.
Illustration 2 g02500079
Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately 30 kg (66 lb). Position electric starting motor (2) in the flywheel housing and install bolts (1).
Connect the harness assemblies to electric starting motor (2). Refer to Specifications, "Electric Starting Motor".
Connect the battery.