CONTROL & MTG GP-ENGINE ELEK 4791894 - Caterpillar

PARTS NEEDED
6 ? 9X3402 Sockets
1 - 1552274 Plug Kit - Connector
1 - 2225655 Wiring Harness
1 ? 2140890 Pre-Heater Display *(OptionalPart Needed: See Illustration for verification)ACTION REQUIRED
See the attached Rework Procedure.SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts Labor Hrs Parts Labor Hrs Parts Labor Hrs
0-4000 / 0-24 Months 100% 1 0 0 0 0
4001-6000 /
25-36 months 33 1/3% 0.5 0 0 50% 0.5
This is a 1?hour job.PARTS DISPOSITION
Handle the parts in accordance with your WarrantyBulletin on warranty parts handling.Attach. (1-Rework Procedure)Rework Procedure
Parts Required:
Quantity Part Number Part Name
1 2225655 Wiring Harness
1 1552274 DT Plug Kit (6 Pin)
6 9X3402 DT Sockets
1 2140890* Pre-Heater Display* Optional Part needed: See Illustrationfor verificationRepair Instructions:
Remove Connector X61 from the 1647513 Wiring Harnessby cutting the wires directly behind Connector X61. Connector X61 is theconnector that plugs directly into the 1910385 Pre-heater Control.
Install six 9X3402 Sockets onto the wires.
Install the wires into a new 1552274 DT Plug Kitaccording to the table below:
Wire Name Position
614-PU-18 1
A571-PU-18 2
A572-PK-18 3
142-RD-18 4
200-BK-18 5
142-RD-18 6 (no function)
Verify, which Pre-Heater Display is installed(see illustration 1). If 214-0890 Pre-Heater Display (B) is installed proceedwith step 5. If the 195-0385 Pre-Heater Display (A) is installed proceedwith step 4.
If the 191-0385 Pre-Heater Display (A)is installed remove and install the 214-0890 Pre-Heater Display (B) intothe side panel.
Install the 2225655 Wiring Harness intothe 2140890 Pre-Heater Display and Connector X61. Install the other endof the 2225655 Wiring Harness into the modified Connector X61.
Verify that the 2140890 Pre-Heater Displayworks correctly. See the 554 and 574 Forwarder OMM for further information(SEBU7197).