CONTROL GP-FUEL INJECTION 4P7031 - Caterpillar

Location of components
Illustration 1 g03687007
Pictorial View
Illustration 2 g03687213
Exploded View
Illustration 3 g03687254
Hose Installation (N1) Broom motor group front Port "A" to hose "WTM" and male quick disconnect for left-hand broom (N2) Broom motor group rear Port "B" to main motor lower Port "B" for left-hand broom (N3) Main motor upper Port "A" to hose "WTF" and female quick disconnect (N4) Broom motor group front Port "A" (N5) Broom motor group rear Port "B" (WTF) Existing Hose (WTM) Existing Hose (MM) Main Motor
Illustration 4 g03687282
Left Hand Gutter Broom Configuration (N4) Broom motor group front Port "A" to hose "WTM" and male quick disconnect for left-hand broom (N5) Broom motor group rear Port "B" to main motor lower Port "B" for left-hand broom
Illustration 5 g03687296
Right Hand Gutter Broom Configuration (N4) Broom motor group rear Port "A" to main motor lower Port "B" for right-hand broom (N5) Broom motor group front Port "B" to hose "WTM" and male quick disconnect for right-hand broomInstallation Procedure
Install one plate (17) to each side of the frame group. Use the following hardware on each side.
Three lock washers (23)
Three bolts (28)
Three hard washers (31)
Install outside mount assembly (10) to the frame group. Use the following hardware.
One inside mounting plate (16)
Six lock washers (23)
Six hard washers (31)
Six bolts (35)
Install fitting (29) to the end of pin (18) .
Attach film (5) to plate assembly (11). Install plate assembly (11) onto mount assembly (10) with pin (18). Use the following hardware.
Two bearings (2)
Spring pin (26)
Washer (42)
Install two nuts (33) and bolt (38) onto plate assembly (13) .
Install plate (3) onto plate assembly (13). Use the following hardware.
Two lock washers (24)
Two nuts (34)
Two hard washers (36)
Two carriage bolts (41)
Install