CONTROL GP-GENERATOR SET 5034411 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Reports have been received that the boom may move or drift after returning the joystick to the Neutral position on the machine listed above. This issue has also been reported that the movement or drift may occur with any implement movement around 25 mm (1.0 inch) of additional travel.Solution
In the event of failure, ensure the latest 546-5412 Machine Software Gp is installed on the machine.
Illustration 1 g06282885
(A) Optional multifunction display
(B) AnalyserUsing the personalities menu through the hand held analyser (B) or optional multifunction display (A), adjust the affected implement "decel" values to 0mA and reset the machine.