CONTROL GP-DEF TRANSFER 5280436 - Caterpillar

Illustration 1 g06054553
Table 1
Specification for 368-6465 Flywheel Housing Gp
Item Qty Part Specification Description
During assembly, the front face of the flywheel housing and the rear face of the cylinder block must be free of following substances: Oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material. Apply ultra blue Loctite 587 to seal the joints between the cylinder block, the flywheel housing, and the oil pan joint.
1 3 5F-0304 Plug Torque to 35 14 N m (26 10 lb ft).
Illustration 2 g06054552
Table 2
Item Qty Part Specification Description
2 5 165-3931 Bolt Use the following procedure to tighten the bolts of the flywheel housing:
1. Tighten bolt 1 through bolt 9 to 100 20 N m (75 15 lb ft) in the numerical sequence as shown in Illustration 1.
2. Tighten bolt 10 through bolt 24 to 40 10 N m (30 7 lb ft) in the numerical sequence as shown in Illustration 1.
3. Loosen all bolts one full turn.
4. Again, tighten bolt 1 through bolt 24 to 135 20 N m (100 15 lb ft) in the numerical sequence as shown in Illustration 1.
3 8 165-3929 Bolt
4 2 165-3934 Bolt
5 9 5J-5793 Bolt