CONTROL 5349851 - Caterpillar

Typical Example2. Remove plug (3) and move plate (2) in towards the center of the machine as far as possible. Install plug (3) back in the plate.
Illustration 7. Step 2 eliminates the hydraulic pressure that forms between seal plate (2) and pivot shaft retainer plate (A). This step also allows adequate clearance between trunnion assembly (4) and plate (2).
Typical Example3. Install the guide pins in the track roller frame.
Typical Example4. Start trunnion assembly (4) on the guide pins.
Typical Example5. Install trunnion assembly (4) with 16 washers (5) and bolts (6).6. Tighten bolts (6) to a torque of 240 40 N m (175 30 lb ft).7. Repeat Steps 1 through 6 for the other side of the machine.Bulldozer Assembly (With Single Tilt)
Necessary Parts
Assembly Procedure
1. Raise and block the bulldozer blade in an upright position. 2. On each side, install connector assembly (1) to the blade with pin (2), retainer (3), and two bolts (4). Tighten bolts (4) to a torque of 430 60 N m (315 44 lb ft). 3. On each side, install arm group (5) to the blade with pin (6), retainer (7), and two bolts (8). Tighten bolts (8) to a torque of 430 60 N m (315 44 lb ft). 4. On the right side, install tilt cylinder group (17) to bulldozer blade with cap, shims, four bolts, and four nuts. See the topic entitled Shimming Procedure in this Special Instruction for shimming instructions. Tighten bolts to a torque of 700 90 N m (515 65 lb ft). The items not numbered are part of the tilt cylinder group. 5. Install the tilt cylinder group to the right hand arm group with pin (18), retainer (7), and two bolts (8). Tighten bolts (8) to a torque of 430 60 N m (315 44 lb ft).Earlier Models
6. Install brace group (9) to bulldozer blade with cap, shims, four bolts, and four nuts. See the topic entitled Shimming Procedure in this Special Instruction for shimming instructions. Tighten bolts to a torque of 700 90 N m (515 65 lb ft). The items not numbered are part of the brace group. Adjust brace group to the neutral position (as shown in Step 8) before installation to push arm.7. Install brace group to left hand push arm with pin (18), retainer (7), and two bolts (8). Tighten bolts (8) to a torque of 430 60 N m (315 44 lb ft).
(A) 1349 mm (53 in).8. Adjust brace group (9) to distance (A). This is the neutral position. Apply a heavy coating of multipurpose type grease to the threaded surfaces on brace group (9).Later Models
Illustration 8.6.