CONTROL GP-JOYSTICK 5396715 - Caterpillar

Illustration 1 g00772839
Illustration 2 g00772841
Remove two bolts (5) and retainers (4) that hold ring (6) in position in flange (3).
Remove bolts (2 ) that hold flange (3) and tube (1).
Illustration 3 g00772842
Remove two bolts (7) and retainers (8) that hold ring (10) in position in flange (11).
Remove bolts (9) that fasten flange (11) and tube (1) to the valve.
Remove tube (1).
Illustration 4 g00772843
Remove bolts (12) and valve (13) from elbow (14).
Illustration 5 g00772844
Remove gauge (15).
Illustration 6 g00772845
Remove the two bolts and the retainers that hold the ring in position on tube (16). Remove the two bolts on the opposite end of the tube. Remove tube (16).
Illustration 7 g00772846
Remove two bolts (17) and the retainers that hold the ring in position on tube assembly (19).
Remove four bolts (20) and the gasket from the water temperature regulator housing.
Remove the bolt and two clips (18). Remove tube assembly (19).
Illustration 8 g00772847
Remove bolts (24) that fasten tube assembly (21) to the pipe assembly. Remove the gasket.
Remove nuts (22). Remove tube assemblies (21) and (23).
Illustration 9 g00772887
Remove nuts (25) and tube assembly (26).
Illustration 10 g00772888
Remove hose assembly (27) and tube assembly (28) from separator assembly (29).
Illustration 11 g00772908
Remove nuts (30) from the studs of the heat exchanger.
Remove three bolts (31) and use two technicians to remove separator assembly (29). The weight of the separator assembly is 39 kg (85 lb).
Illustration 12 g00772909
Remove four gaskets (32) from the heat exchanger.
Illustration 13 g00772910
Position a nylon strap (33) and a suitable lifting device on heat exchanger (34).
Illustration 14 g00772911
Remove bolt (35) that is used to fasten the heat exchanger to the frame.
Illustration 15 g00772930
Remove two bolts (36) that fasten the heat exchanger to the frame.
Remove the heat exchanger. The weight of the heat exchanger is 426 kg (940 lb).