CONTROL AS 5593363 - Caterpillar

(1) Type of torque hub ... planetary gearReduction ratio ... 70.91 to 1(2) Type of brake ... multiple disc spring appliedStatic ... 490 N m (360 lb ft)Release ... 930 kPa (135 psi)Maximum ... 20 670 kPa (3000 psi)(3) Sprocket(4) Propel motor Type ... variable displacementMaximum displacement ... 55 cm3/rev (3.35 in3/rev)Minimum displacement ... 27 cm3/rev (1.64 in3/rev)Loop flushing ... 2200 kPa (320 psi)(5) Tighten bolt to a torque of ... 460 N m (340 lb ft)(6) Oil fill and check plugs ... located 90° apartPropel Motor
(1) Tighten plug to a torque of ... 38 N m (28 lb ft)(2) For the relief valve, tighten the following to a torque of: a. Adjustable screw and locknut ... 52 N m (38 lb ft)b. Plug ... 95 N m (70 lb ft)(3) Tighten locknut on maximum displacement limit screw to a torque of ... 54 N m (40 lb ft)(4) Tighten plug to a torque of ... 20 N m (14 lb ft)(5) Tighten plug to a torque of ... 36 N m (26 lb ft)(6) Tighten plug to a torque of ... 36 N m (26 lb ft)(7) Tighten plug to a torque of ... 20 N m (14 lb ft)(8) Tighten the following to a torque of: a. Four short socket head cap screws ... 70 N m (51 lb ft)b. Four long socket head cap screws ... 60 N m (44 lb ft)(9) Tighten four bolts to a torque of: a. Standard grade ... 14 N m (10 lb ft)b. Grade 12.9 ... 16 N m (12 lb ft)(10) Tighten plug to a torque of ... 34 N m (25 lb ft)(11) Tighten plug to a torque of ... 54 N m (40 lb ft)(12) Tighten bolts to a torque of: a. Six long bolts ... 90 N m (66 lb ft)b. One small bolt ... 30 N m (22 lb ft)(13) Tighten plug to a torque of ... 40 N m (30 lb ft)(14) Tighten plug to a torque of ... 36 N m (26 lb ft)(15) Tighten plug to a torque of ... 40 N m (30 lb ft) (16) Speed sensor Type ... magneticInstallation: * Carefully screw the speed sensor (16) into threaded port until internal contact is reached with the gear outside diameter (18).* Back the sensor out 1/4 to 1/2 turn (90° to 180°)* Torque hex nut (17) to ... 13.6 N m (10.1 lb ft)* Clean threads and apply Loctite 242Planetary Group
(1) Due-Cone Seal.Reference For Assembly of Due Cone Seals, refer to AP-650B/BG-225C Disassembly and Assembly Service Manual Form No. KENR 3559.(2) Bearings. Apply SAE 30 CD oil to all bearings and mating surfaces prior to assembly.(3) Nut. Apply 9S-3263 Thread Lock to the threads and contact surfaces prior to assembly. Tighten bearing locknut to a torque of ... 950 N m (700 lb ft)(4) Apply 9S-3263 Thread Lock to the threads prior to assembly and tighten eight cover bolts to a torque of ... 12 N m (9 lb