CONTROL VALVE GROUP 5J9115 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Inspect the O-ring seals, the seals, and the gaskets. Replace the O-ring seals, the seals, and the gaskets that are worn or damaged.Note: Lubricate O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g01967755
Install O-ring seal (19) .
Illustration 2 g01967754
Install gear pump (18). Install bolts (17). Tighten bolts (17) to a torque of 55 10 N m (41 7 lb ft).
Illustration 3 g01967735
Install housing (16). Install bolts (15). Tighten bolts (15) to a torque of 55 10 N m (41 7 lb ft). Install tube assembly (14). Tighten tube assembly (14) to a torque of 42 2 N m (31 2 lb ft). Install tube assembly (13). Tighten tube assembly (13) to a torque of 172.5 7.5 N m (127 6 lb ft).
Illustration 4 g01967734
Install seal (12) .
Illustration 5 g01951864
Position oil pan (11) and install bolts (10). Tighten bolts (10) to a torque of 55 10 N m (41 2 lb ft).
Illustration 6 g01951860
Install screen (9) and magnetic filter (8) .
Install O-ring seal (7) .
Illustration 7 g01951854
Install cover (6) and bolts (5). Tighten bolts (5) to a torque of 28 7 N m (20 5 lb ft).
Illustration 8 g01951853
Install output shaft (4). Install bearing assembly (3). Install retaining ring (2) and retaining ring (1) .End By: Connect the transmission from the engine. Refer to Disassembly and Assembly, "Engine, Torque Converter, and Transmission - Connect".