CONTROL GP-EMCP ELECTRONIC 7C6513 - Caterpillar

TYPE="TABLE" @@@-->
Install elbow adapters (32).
Illustration 19 g06324161
Install tube assembly (31) with toggle valve assembly (30).
Install tube assembly (28) with elbow adapter (29).
Illustration 20 g06324156
Install bracket (26) with bolt (25), screw (23), and nut (27). Tighten nut (27) to a torque of 12 1.2 N m (106 11 lb in).
Illustration 21 g06324153
Install plate (24) and screws (23).
Illustration 22 g06324147
Note: Assemble tie rod (22) to provide equal thread engagement in each rod end (20). Nuts (21) and tie rod ends (20) will be torqued after adjusting tie rod (22) with levers.
Fill tie rod ends (19) with Multi-Purpose grease. Install seals (18) on tie rod ends (19).
Install nuts (21) and tie rod ends (20) onto tie rod (22).
Illustration 23 g06324138
Install woodruff key (18).
Illustration 24 g06324130
Install lever (15) and tie rod assembly (17).
Install bolts (14) and (16). Tighten bolt (16) with jam nut to a torque of 30 5 N m (22 4 lb ft).
Illustration 25 g06324666
Install plunger assembly (13) into lever (10).
Illustration 26 g06324114
Install lever (10) with bolt (12) and shoulder bolt (11). Tighten bolt (12) with jam nut to a torque of 30 5 N m (22 4 lb ft).
Illustration 27 g06325017
Rotate lever (10) to main run position until valve touches stop pin inside the cover assembly.
With the lever (10) in main run position, screw plunger assembly (13) into lever until plunger assembly ball seats into the top hole in the bracket.
Adjust tie rod assembly to lever and handle positions.
Tighten nuts (21) to a torque of 30 5 N m (22 4 lb ft).
Illustration 28 g06324082
Install three engine oil filter elements (8) and O-ring seal (9).
Illustration 29 g06324080
Install oil filter cover (7) and bolts (6).
Illustration 30 g06324074
Install engine oil filter element (4) and O-ring seal (5).
Illustration 31 g06324063
Install dowel pin (3).
Illustration 32 g06324059
Install oil filter cover (2) and bolts (1).