CONTROL GP-BUCKET 7K9802 - Caterpillar

Install gasket (20) and plate (21) .
Illustration 24 g00283156
Install housing (18) and bolts (19) . Tighten bolts (19) to a torque of 33 2 N m (24 15 lb ft).
Illustration 25 g00283155
Install coupling (17) .
Illustration 26 g00283154
Install flex plate (16) and the seals.Note: The bronze face of the flex plate must be facing toward the rotor.
Illustration 27 g00283153
Install vanes (15) , rotor (14) , and ring (13) .Note: The vanes must be installed so that the leading edge is facing toward the direction of travel.
Illustration 28 g00283152
Install flex plate (12) .Note: The bronze face of the flex plate must be facing toward the rotor.
Illustration 29 g00283151
Turn the plate onto the opposite side and install seals (11) .
Illustration 30 g00928727
Install bearing (10) and retaining ring (9) .
Install ring seal (9B) and O-ring seal (9A) .
Illustration 31 g00283149
Install plate (8) and the shaft.
Illustration 32 g00283147
Install bolts (7) . Tighten bolts (7) to a torque of 12 3 N m (106 27 lb in).
Illustration 33 g00283146
Install retaining ring (6) on the shaft.
Illustration 34 g00283145
Install cartridge (5) .
Illustration 35 g00937422
Install ring (4B) and O-ring seal (4A) .
Install ring (4) .
Illustration 36 g00937362
Install O-ring seal (3) to cover (2) .
Illustration 37 g00936839
Install cover (2) .
Install bolts (1) to cover (2) . Tighten bolts (1) to a torque of 204 14 N m (151 10 lb ft).End By: Install the hydraulic pump. Refer to Disassembly and Assembly, "Piston and Vane Pump (Steering and Implement) - Install".