CONTROL GP-GOVERNOR 7T2511 - Caterpillar

Illustration 4 g02022400
If necessary, follow Step 6.a through Step 6.d in order to remove pulley (8) from alternator (2) .Note: Either of Tooling (A) may be required in order to carry out the removal of the alternator pulley.
Place alternator (2) in a suitable support.
Hold shaft (10) of alternator (2) with Tooling (A). Use a cranked ring spanner to loosen nut (9) .
Make a temporary mark on pulley (8) in order to show the correct orientation.
Remove nut (9) and pulley (8) from shaft (10) .
Illustration 5 g02022403
Illustration 6 g02022404
If necessary, follow Step 7.a through Step 7.d in order to remove alternator bracket (11) from the cylinder block.
If necessary, remove bolt (14) and remove flat idler pulley (13) from alternator bracket (11) .
If necessary, remove belt tensioner (15) from alternator bracket (11). Refer to Disassembly and Assembly, "Belt Tensioner" for the correct procedure.
Remove bolts (12) from alternator bracket (11). Remove the alternator bracket from the cylinder block.Note: Support the weight of the alternator bracket as the bolts are removed.
Note the position of dowels (16) in alternator bracket (11) .Installation Procedure
Illustration 7 g02022404
Illustration 8 g02165615
Illustration 9 g02352950
If necessary, follow Step 1.a through Step 1.g in order to install alternator bracket (11) onto the cylinder block.
Ensure that alternator bracket (11) is clean and free from wear and damage. If necessary, replace the alternator bracket.
Ensure that dowels (16) are free from wear and damage. If necessary, replace the dowels.
Install Tooling (B) to the cylinder block.
Position alternator bracket (11) onto Tooling (B). Install bolts (12) hand tight.
Remove Tooling (B) and install remaining bolts (12) hand tight.
Tighten bolts (12) to a torque of 44 N m (32 lb ft).
If necessary, install belt tensioner (14) onto alternator bracket (11) and tighten bolt (15). Refer to Disassembly and Assembly, "Belt Tensioner" for the correct procedure.
Illustration 10 g02019754
Typical example
If necessary, follow Step 2.a through Step 2.d in order to install pulley (8) to alternator (2) .Note: Either of Tooling (A) may be required in order to carry out the installation of the alternator pulley.
Place alternator (2) in a suitable support.
Ensure that pulley (8) is correctly oriented.
Install pulley (8) and a new nut (9) to alternator shaft (10) .
Position a cranked ring spanner onto nut (9) and use a suitable tool in order to prevent the cranked ring spanner from turning. Use Tooling (A) in order to turn the shaft of the alternator in a counterclockwise direction. Tighten the nut