CONTROL GP-ENGINE MONITORING 9X8203 - Caterpillar

Illustration 2 g01826497
Detail A
Manifold
(13) Torque for two plug assemblies ... 18.5 1.0 N m (163.7 8.9 lb in)
Illustration 3 g01826791
View B-B
(14) Apply a continuous bead of 4C-9612 Silicone Sealant to the T-shaped joints immediately before you install the gasket for the oil pan (15). The application of the sealant should cover the entire width of the T-shaped joints. (17) Apply 4C-9612 Silicone Sealant immediately before you assemble the torque converter housing (16). After assembly of the torque converter housing, remove excess sealant from the flange with a straight edge. Apply the sealant again.
Illustration 4 g01867973 (18) Torque for six plug assemblies ... 36.75 1.75 N m (27.11 1.29 lb ft)Note: Apply a continuous bead of 4C-9612 Silicone Sealant to the surface of the hard washer (19) and to the threads of the bolt (20). (20) Torque for the bolt ... 100 20 N m (74 15 lb ft) (21) Torque for three plug assemblies ... 8 1 N m (71 9 lb in)
Illustration 5 g01867993 (22) 340-9914 Spring Length under test force ... 32.21 mm (1.268 inch)Test force ... 125 20 N (28 4.5 lb)Free length after test ... 33.69 mm (1.326 inch)Outside diameter ... 19.34 mm (0.761 inch) (23) Torque for the bolt ... 100 20 N m (74 15 lb ft) (24) 340-9915 Spring Length under test force ... 60.78 mm (2.393 inch)Test force ... 200 25 N (45 6 lb)Free length after test ... 62.87 mm (2.475 inch)Outside diameter ... 20.23 mm (0.796 inch)