CONTROLLER AS 4499113 - Caterpillar

Table 1
Required Tools
Tool Part Number Part Description Qty
A(1) 5P-7306 Housing 1
5P-7305 Engine Turning Tool 1
B 435-3146 Timing Pin (Camshaft) 1
(1) This Tool is used in the aperture for the electric starting motor.
Illustration 1 g02862116
Typical example
If necessary, remove the accessory drive. Refer to Disassembly and Assembly, "Accessory Drive - Remove and Install" for the correct procedure. Remove plug (1) from the engine. Use Tooling (A) in order to rotate the crankshaft in the normal direction of rotation.
Install Tooling (B) into Hole (X) in the engine. Use Tooling (B) in order to locate the camshaft in the correct position. Note: Do not use excessive force to install Tooling (B). Do not use Tooling (B) to hold the camshaft during repairs.
If the shaft for the fuel injection pump is not in the position shown in illustration 2, the timing of the fuel injection pump may be incorrect. If necessary, remove the fuel injection pump. Refer to Disassembly and Assembly for the correct procedure.
Illustration 2 g02906337
Typical example
Ensure that the camshaft is in correct position. If necessary, install the fuel injection pump. Refer to Disassembly and Assembly for the correct procedure. Ensure that the fuel injection pump shaft is in the correct position as shown in illustration 2. The Angle (Y) should be 45 degrees.
If necessary, remove Tooling (B). Install plug (1) to the engine.
If necessary, install the accessory drive . Refer to Disassembly and Assembly, "Accessory Drive - Remove and Install" for the correct procedure.