CONTROLLER 4538834 - Caterpillar

Procedure for Changing Work Tool Parameters using the Monitor
Note: There are three types of monitors, D series Monitors, F series Monitors, and Mini Monitors. All parameters that need to be changed are in the same area, "Tool Programming" under the "Service" menu. The following procedures show an example of an F series Monitor.
Illustration 1 g06104990
Select"Tool Programming" under "Service" menu. (Service Password is required).
Illustration 2 g06104995
Select the "Tool Type" for the corresponding Hammer sales model.
Select the parameters listed below and replace the default values with the values listed in Table 1:
Tool Program Name
Tool Program Variable Relief Valve #1 Pressure
Tool Program Variable Relief Valve #2 Pressure
Tool Program Hydraulic Temperature High Warning Event Threshold
Tool Program Attachment Valve #1 Flow Setting
Tool Program Attachment Valve #1 Multi– Operation Additional Flow
Tool Program Attachment Valve #1 One Way / Two Way Valve ModeNote: The parameters listed above are minimum requirements. Other parameters may need to be changed based on the machine configuration / application. Refer to System Operation and Testing and Adjusting publications for the corresponding Hydraulic Excavator.Procedure for Changing Work Tool Parameters using Cat Electronic Technician
Illustration 3 g02713701
Diagnostic connector for Cat Electronic Technician
Connect the Cat Electronic Technician to the diagnostic connector.
Illustration 4 g02713758
Start Cat Electronic Technician.
Illustration 5 g02713761
Select the ECM for "Machine Control".
Illustration 6 g02714358
Select "Tool Configuration" from the "Service" menu.
Illustration 7 g02722754
Work tool list (typical example)
Highlight the tool to view or change the parameters. Click "Configure" in the bottom right corner of the screen.
Illustration 8 g02722968
Work tool parameter list (typical example)
Highlight the parameter and click "Change" on the lower left corner of the screen to change the parameter. Select the parameters listed below and replace the default values with the values listed Table 1:
Tool Program Name
Tool Program Variable Relief Valve #1 Pressure
Tool Program Variable Relief Valve #2 Pressure
Tool Program Hydraulic Temperature High Warning Event Threshold
Tool Program Attachment Valve #1 Flow Setting
Tool Program Attachment Valve #1 Multi– Operation Additional Flow
Tool Program Attachment Valve #1 One Way / Two Way Valve ModeNote: The parameters listed above are minimum requirements. Other parameters may need to be changed based on the machine configuration / application. Refer to System Operation and Testing and Adjusting publications for the corresponding Hydraulic Excavator.