CONVERSION AR-MACHINE 3534296 - Caterpillar

When Required
Engine Air Intake System - Service filters Ether Starting Aid (If Equipped) - Replace empty cylinder Batteries - Inspect Electric Fuel Refueling Pump (If Equipped) - Clean strainer Radiator - Clean or Replace Pressure Cap Fuses - Replace Windshield Wiper and Washer - Inspect/Replace Bucket Tips and Side Cutters - Replace if damaged Bucket Clearance - Inspect/Adjust Oil Filter Inspection - Inspect Used Filter for Debris Tracks - Adjust Automatic Engine Speed Control - Test Air Conditioner (If Equipped) - Check the amount of refrigerant. Inspect and/or Adjust the Belt. Clean the condenser. Clean filters.Every 10 Service Hours or Daily
Engine Oil - Check DEO oil level Hydraulic Oil - Check HYDO oil level Cooling System - Check coolant level Fuel Tank - Drain water and sediment Walk - Around Inspection - Inspect machine Undercarriage - Check for oil leaks, wear and loose bolts Seat Belt - Inspect Indicators and Gauges - Test Backhoe Linkage - Lubricate under severe operating conditions, etc.Every 50 Service Hours or Weekly*
Backhoe Linkage - Lubricate 18 fittingsInitial 100 Service Hours*
Hydraulic System - Service strainer and filters Final Drives - Change TDTO oil Swing Drive - Change TDTO oilEvery 100 Service Hours (Only for Hydraulic Hammer Machine)*
Hydraulic System - Service strainer and filtersEvery 250 Service Hours or Monthly*
Engine Oil and Filter - Change DEO oil and filter. If the sulfur content in the fuel is greater than 1.5 % by weight, use an oil with a TBN of 30 and reduce the oil change interval by one half Engine Valve Lash - Adjust on new or reconditioned engines at first oil change only Engine Crankcase Breather - Clean Fuel Filters - Service filters Fuel Inlet Screen - Clean Cooling System Hoses - Inspect/Check Belts - Inspect/Adjust Cooling System - Add conditioner Final Drives - Check TDTO oil level Swing Drive - Check TDTO oil level Swing Bearing - Lubricate 2 fittings Water Separator - Check the red ring in the bowl and drain waterEvery 500 Service Hours or 3 Months*
Engine Air Intake System - Service filters Hydraulic System - Service strainer and filters Fuel Tank Cap and Fill Screen - Clean Swing Internal Gear - Add grease/Check teethEvery 600 Service Hours (Only for Hydraulic Hammer Machine)*
Hydraulic System - Change HYDO oil and Suction StrainerEvery 1000 Service Hours or 6 Months*
Engine Air Intake System - Change filters Swing Drive - Change TDTO oilEvery 2000 Service Hours or 1 Year*
Cooling System Coolant - Change coolant Final Drives - Change TDTO oil Engine Valve Lash - AdjustEvery 2000 Service Hours or 2 Years*
Hydraulic System - Change HYDO oil and Suction Strainer*First Perform Previous Service Hours Items.