CONVERSION AR-7 ROLLER FRAME 5Y0569 - Caterpillar

Installation of the LED Indicator
Inside the cab, remove the upper right hand overhead console.Note: You may need to remove the right hand window in order to remove the upper right hand overhead console.
Remove the back of the upper right hand overhead console.
Mark the LED indicator location 85 mm (3.35 inch) from the right edge of console and 90 mm (3.5 inch) from the bottom edge of console as shown in Illustration 16. Mark the site with a center punch.Note: Place a stop on the drill bit to prevent drilling depth of more than 6 mm (0.25 inch). This is to prevent any damage to the machine harness and/or components.
Drill a 13 mm (0.50 inch) hole at the marked location.
Illustration 16 g01095084
Upper right hand console showing location of LED indicator.
Route the three LED indicator wires through the 13 mm (0.50 inch) hole. Install the LED indicator into the hole. Make sure that the LED indicator locks into place.
Place the wires of the LED indicator into the 102-8803 Receptacle Kit (3-PIN). The pin locations are as follows:
Table 3
Wire Table for LED Indicator Connector    
A     Red Wire    
B     Black Wire with Green Cover    
C     Black Wire    
Illustration 17 g01095092
Locate the 12 pin plug at the back of the RH Lamp Group and unplug.
Remove the plug wedge and remove the following wires:
Pin 2 (200-BK)
Pin 4 (G848-GN)
Pin 8 (F846-PU)
Seal the back of the 12 pin plug by inserting the 8T-8737 Seal Plug in wire holes 4 and 8.
Insert a socket end of the 207-3814 Wire As. into the pin 2 location of the 12 pin plug.
Reapply the wedge to the 12 pin plug and reconnect to the RH Lamp Group.
Insert the pin end of the 207-3814 Wire As. into one end of the 115-8109 Sealed Splice .
Insert wire 200-BK (removed from 12 pin plug in Step 8) into the other end of the sealed 115-8109 Sealed Splice .
Insert the remaining wires into the 155-2260 Plug Kit as follows:
Table 4
Wire Table for 155-2260 Connecting Plug Kit    
A     F846-PU    
B     G848-GN    
C     207-3814 Wire As. (socket end)    
Insert the wedge into the plug.
Connect the 155-2260 Plug Kit to the 102-8803 Receptacle Kit (3-PIN) from the LED indicator.
Re-assemble the upper right hand overhead console.
Reinstall the upper right hand overhead console onto the machine.
Reconnect the grounded battery cable to the negative post of the battery.Setup of the Machine Security System (All Machines)
Set up the Product Identification Number of the machine, date and time, and bypass schedule as described in Service Manual,