CONVERTER AR-TRQ 10R0897 - Caterpillar

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures.Cooling System
Change Coolant/Clean System
Do not change the coolant until you read and understand the material in the topic Cooling System Specifications in the Maintenance Section of this manual.
Drain the coolant earlier whenever the coolant is dirty or foaming is observed. The radiator cap is located in the top of the hood. 1. Remove the radiator cap slowly to relieve pressure.2. Open the drain valve and allow the coolant to drain. Drain valve is located under the radiator.3. Close the drain valve. Fill the system with clean water and a 6 to 10 percent concentration of cooling system cleaner.4. Start and run the engine for 90 minutes. Stop the engine and drain the cleaning solution.5. Flush the system with water, with the engine stopped, until the draining water is clear.6. Close the drain valve.7. Add the coolant solution. See the topic Cooling System Specifications and Lubricant Viscosities and Refill Capacities chart in the Maintenance Section of this manual. Do not add supplemental coolant additive or change element at this time, unless you are not using Caterpillar Antifreeze which contains additive.8. Start the engine and operate it with the radiator cap off, until the thermostat opens and the level stabilizes.9. Maintain the coolant level to within 13 mm (.50 in) of the bottom of the fill pipe.10. Replace the cap if the gasket is damaged. Install the cap.11. Stop the engine.