COOLER GP-ENGINE OIL 1172753 - Caterpillar

Above 60°F (16°C)
Inspect seat belt and attaching devices. Replace any defective components.Fasten seat belt.
1. Move transmission range selector to NEUTRAL and engage neutral lock. 2. Apply parking brake. 3. Move cushion hitch lever to LOCK DOWN. 4. Move all hydraulic controls to HOLD. 5. Turn disconnect switch on.
Never turn disconnect switch off with engine running.
MACHINE SERIAL NUMBERS 24W1355-UP and 66W662-UP LOW AIR PRESSURE LIGHT should come on and electric horn should sound when air pressure is below 60 psi (415 kPa). To test LOW AIR PRESSURE LIGHT and horn when air pressure is above 60 psi (415 kPa), apply and release service brakes to decrease air pressure in the reservoirs. LOW COOLANT FLOW LIGHT and PARKING BRAKE SET LIGHT should go on.With sufficient air pressure, air horn should sound in conjunction with LOW COOLANT FLOW. MACHINE SERIAL NUMBERS 24W1-24W1354 AND 66W1-66W661 LOW COOLANT FLOW LIGHT and ... ... PARKING BRAKE SET LIGHT should go on.
Correct any malfunction before operating machine.
6. Depress accelerator to just past STOPPED detent. 7. Push in and turn heat start switch to START. Release switch when engine starts.
If engine oil pressure does not register when engine starts, stop engine and have corrections made.
If engine did not start, turn heat start switch to heat for 30 seconds, then to start.Below 60°F (16°C)
1. Follow steps 1 through 6 under Above 60°F (16°C). 2. Push in and turn heat start switch to HEAT for time indicated on starting aid chart. 3. Push in and turn heat start switch to START. Release switch when engine starts. 4. It may be necessary to return heat start switch to HEAT until engine runs smoothly. If engine did not start in 10 seconds turn heat start switch to HEAT for 30 seconds then to start.
If engine does not start after two attempts, the use of starting fluid should be considered to prevent battery drain and overheating of starting motor.
When Starting Fluid is Required
Use starting fluid sparingly. Follow manufacturer's instructions carefully.Do not store starting fluid containers in operator's compartment.
1. Perform steps 1 through 6 for Above 60°F (16°C). 2. Push in and turn heat start switch to HEAT for indicated time on STARTING AID CHART. 3. Push in and turn heat start switch to START. 4. Spray starting fluid into the precleaner for 1 second then wait for 2 seconds before spraying again.5. When engine starts it may be necessary to turn heat start switch to HEAT until engine runs smoothly.Starting from External Source
Do not allow cable ends to contact each other or the machine.Prevent sparks near batteries that could cause vapors to explode.
Turn disconnect switch off and remove key when attaching cables.Connect cables POSITIVE (+) to POSITIVE (+) and NEGATIVE (-) to NEGATIVE (-).
1. Connect one cable to the POSITIVE (+) terminal of the battery of the machine to be started. Attach other end to POSITIVE (+) terminal of starting source.2. Connect second cable to NEGATIVE (-) terminal of starting source. Attach other end to starter ground terminal of machine to