COOLER AS. 2763075 - Caterpillar

Fusion Bucket
Table 4
Required Parts for Conversion of 345-2784 General Purpose Bucket Gp to 451-1403 General Purpose Bucket Gp (S & G)
Item Qty Part Number Description
1 4 332-5803 Wear Plate
2 2 430-3295 Side Plate
Table 5
Required Parts for Conversion of 345-2426 General Purpose Bucket Gp to 451-1404 General Purpose Bucket Gp (S & G)
Item Qty Part Number Description
1 4 332-5817 Wear Plate
2 2 345-2798 Side Plate
Table 6
Required Parts for Conversion of 345-2428 General Purpose Bucket Gp to 469-0191 General Purpose Bucket Gp (S & G)
Item Qty Part Number Description
1 4 360-3248 Wear Plate
2 2 360-3328 Side Plate Installation Procedure
Note: Refer to REHS1841 for general weld instructions. Temperature on the bottom surface of the cutting edge must not exceed 450 C during welding.
Illustration 1 g06325656
(1) Wear Plate
(D1) 95.0 mm (3.74 inch)
(W1) 6.0 mm (0.23 inch) fillet weld - 4 places
(W2) 8.0 mm (0.31 inch) V- groove weld - 4 places
Weld four wear plates (1) (Two on each side) on the bottom of either side of the coupler interface using weld (W1) and weld (W2) as shown in Illustration 1.
Illustration 2 g06325646
(2) Plate
(D2) 20.2 mm (0.79 inch)
(D3) 14.0 mm (0.55 inch)
(W3) 6.0 mm (0.23 inch) all around intermittent fillet weld (At 120 mm & 240 mm) - Both sides
(W4) 6.0 mm (0.23 inch) all around fillet weld (Along the inner circumference) - 6 Places
Weld two plates (2) (One on each side) on both sides of the bucket using weld (W3) and Weld (W4) as shown in Illustration 2.
Illustration 3 g06282912
Typical example
(3) Cutting Edge Gp
Assemble cutting edge (3) to the bucket.
Table 7
Cutting Edge Options
Bucket Width Type of Cutting Edge
3 Piece Bolt On 4Piece Bolt On Rubber Edge (Two-Section)
2524.0 to 2550.0 mm (99.36 to 100.39 inch) 472-1465 8E-4566 251-5418
2750.0 mm (108.26 inch) 472-1468 345-2758 444-1522
3065.0 mm (120.67 inch) 472-1471 - 398-6760