COOLER GP-HYDRAULIC OIL 2W6664 - Caterpillar

Key Off Aftertreatment Regeneration Maximum Time
The "Key Off Aftertreatment Regeneration Maximum Time" parameter determines the maximum permitted time for key-off ARD regeneration.
Table 18
Minimum    Maximum    Default    
5 Minutes     25 Minutes     15 Minutes    High Soot Load Aftertreatment Protection Enable Status
The "High Soot Load Aftertreatment Protection Enable Status" parameter determines whether aftertreatment protection is enabled.
Table 19
Value    Default    
Disabled
Enabled     Enabled    Factory Installed Aftertreament #1 Identification Number
The "Factory Installed Aftertreament #1 Identification Number" determines the serial number of the Clean Emissions Module (CEM) that is installed in the machine.
Table 20
Value    Default    
10 Character Serial Number     AFA1234567    DPF #1 Soot Loading Sensing System Configuration Code
The "DPF 1 Soot Loading Sensing System Configuration Code" parameter determines the type of diesel particulate filter #1 soot loading sensing system. This parameter identifies orientation of soot sensor, and the geometry of the DPF.
Table 21
Value    Default    
20(Hex) to 7F(Hex)     BZ    Miscellaneous
Fan Reversing
Table 22
Parameter    Value    Default    
Reversing Feature     Enabled
Disabled     Disabled    
Purge Cycle Interval     300 to 7200 Seconds     1200 Seconds    
Cold EngineParasitic Load Reduction Installation     Installed/Not Installed     Installed    
Purge Cycle Duration     5 to 60 Seconds     25 Seconds    System Settings
System Operating Voltage Configuration
The System Operating Voltage Configuration parameter is the operating voltage for the engine electrical system.
Table 23
Value    Default    
12 VDC
24 VDC     24 VDC    Passwords
Customer Password 1
The Customer Password 1 is the first security password that can be defined by the customer.
Table 24
Value    Default    
Eight alphanumeric characters     Eight spaces    Customer Password 2
The Customer Password 2 is the second security password that can be defined by the customer.
Table 25
Value    Default    
Eight alphanumeric characters     Eight spaces    Security Access Parameters
CAN Communication Protocol Write Security
The CAN Communication Protocol Write Security parameter control the security required for writing information through the CAN bus.
Table 26
Value    Default    
Seed and Key
No Security     Seed and Key    CAN Communication Protocol Read Security
The CAN Communication Protocol Read Security parameter control the security required for reading information from the CAN bus.
Table 27
Value    Default    
Seed and Key
No Security     Seed and Key