COOLER GP-FLTR BASE & ENG OIL 2W7545 - Caterpillar

Manual Shifting
Move the autoshift switch fully counterclockwise into the MANUAL position. Depressing the left service brake pedal will cause the transmission to downshift. If the transmission neutralizer has not been disabled, the transmission will also neutralize as the machine slows down.The operator must use the transmission speed selector in order to change transmission speeds.Automatic Shifting (Conventional Steering)
Illustration 1 g02845897
Autoshift Selector with Conventional Steering
Move the autoshift switch into one of the two automatic positions.When the autoshift switch is in 2-4 position, the lowest automatic speed for the transmission is SECOND speed. Press downshift button to get to FIRST speed. When the autoshift switch is in 1-4 position, the lowest automatic speed for the transmission is FIRST speed. The transmission will shift into SECOND after a change in direction if the maximum gear is equal to or greater than second gear. Then the transmission will shift automatically according to machine conditions.Note: The machine can be electronically configured by a Cat dealer to start in FIRST after a change in direction.Downshifting (Conventional Steering)
Illustration 2 g02845898
Downshift Switch for Machines that are Equipped With Levers
Manual Shifting
The downshift switch can be used to downshift the machine from SECOND to FIRST in order to load the bucket. The downshift switch is active when the transmission speed selector lever is set to SECOND speed. The transmission will remain at FIRST until gear number selector position increases or direction switch position changes. When either changes, the transmission immediately shifts into gear number selector position.Note: The transmission will only downshift if an engine overspeed will not occur.Automatic Shifting
The downshift switch can be used to downshift from SECOND to FIRST in order to load the bucket. The downshift switch is located near the bucket controls. The downshift switch is located on the joystick on machines that are equipped with a joystick. The downshift switch is active when the autoshift switch is in the automatic modes (2). The transmission will remain in the downshifted speed for 5 seconds after the switch is released. Then, automatic shifting will resume.