COOLER GP- 3894048 - Caterpillar

Illustration 1 g01388839
PMPE generator wiring diagram
(CR1-C6) diodes
(CR7) varistor
(L1) exciter stator
(L2) exciter rotor
(L3) main rotor
(L4) main stator
(L5) PMG stator
(PM) permanent magnet
(RFA) rotating field assembly
(CT1) optional voltage droop transformer
(T0, T1, T2, T3, T7, T8, T9) generator terminals
Table 1
Tools Needed
Quantity Part Number Description
1 300-8648 Insulation Tester - 1kV DC
1 349-4206 Insulation Tester - 5kV DC
Personal injury or death can result from electrocution.The megohmmeter is applying a high voltage to the circuit.To avoid electrocution, do not touch the instrument leads without first discharging them. When finished testing also discharge the generator windings.
The following materials will cause the winding insulation to deteriorate:
Moisture (water)
Dust
Grease
Other foreign matter within the generatorThis deterioration reduces the resistance of the insulation. This test will measure the resistance of the winding insulation. The insulation tester (megohm meter) produces a high potential voltage between the test leads. During the test, a small current will flow. The tester converts this current to a resistance reading.The insulation test is performed as part of periodic maintenance in order to detect the deterioration of the winding insulation. When there is a rapid decrease in the insulation resistance in a short amount of time, the generator needs to be cleaned.Note: For information on generator cleaning, refer to Special Instruction, SEHS9124.When generators have not been used, moisture can accumulate. Therefore, the insulation test should be performed on generators that have been idle. If moisture is known to exist, the windings must be dried prior to testing. Refer to the Testing and Adjusting, "Generator - Dry" section of this publication.The windings must be reconditioned or replaced in the following cases:
The measured insulation resistance falls below the specified amount. The cleanup procedure does not correct the discrepancy.
The measured insulation resistance falls below the specified amount. The drying procedure does not correct the discrepancy.The specified insulation resistance is an approximate value. The generator can be operated with less than the specified value. However, a generator that has a low winding insulation resistance will be more likely to have a failure.
Personal injury or death can result from improper troubleshooting and repair procedures.The following troubleshooting and repair procedures should only be performed by qualified personnel familiar with this equipment.
The insulation test gives accurate results only when the generator windings are free of moisture and the generator windings are at room temperature.Main Stator L4
Remove the load from the generator by either opening the line circuit breaker or the load connections to (T1), (T2), (T3), and (T0). Prevent these wires from coming into contact with each other and prevent these wires from contacting ground.
Isolate main stator (L4) from the voltage regulator by disconnecting wires 20, 22, and 24. If generator lead (T0) is connected to the generator frame or ground, open the connection.
Connect one test lead of the insulation tester (megohm meter) to the generator enclosure (ground).
Connect the other test lead of the insulation tester (megohm meter) to generator lead (T0). Note: Refer to Table 2 for the stator test voltages that must be used. The test voltages are based on the output