COOLER GP-HYD & STEERING OIL 3967331 - Caterpillar

Removal Procedure
Start By:
If the Clean Emission Module (CEM) is mounted on the valve mechanism cover. Removal of the CEM will be necessary in order to access the valve mechanism cover.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02522396
Remove bolts (1) and bolts (4) from bracket (2) and bracket (3). Position brackets and harness assembly away from valve mechanism cover (7).
Disconnect the plastic tube assembly (5) from the valve mechanism cover for the crankcase breather. Refer to Disassembly and Assembly, "Crankcase Breather - Remove" for the correct procedure.
Remove bolts (6) from valve mechanism cover (7).
Remove valve mechanism cover (7) from the cylinder head. Note: Remove the valve mechanism cover vertically in order to avoid damage to the electronic unit injectors.
Illustration 2 g02522397
Remove gasket (8) from valve mechanism cover (7). Installation Procedure
Install valve mechanism cover (7) in the reverse order of removal.
Thoroughly clean all gasket surfaces of valve mechanism cover (7). Clean the gasket surfaces of the cylinder head. Inspect gasket (8) for damage. If necessary, install a new gasket.
Install the valve mechanism cover vertically in order to avoid damage to the electronic unit injectors.
Illustration 3 g02522516
Tighten the bolts in the numerical sequence that is shown in Illustration 3. Tighten the bolts to a torque of 22 N m (195 lb in)